Enable the switch to participate in routing updates from external devices with the router command in global configuration mode.
Enter the no switchport command to disable Layer 2 functionality at the interface level.
Each port participating in routing of Layer 3 packets must have an IP routing protocol assigned on aperinterface level.
Routing is enabled by default on a multilayer switch, so the port can become a Layer 3 routing interface by assigning the appropriate IP address and subnet information.
第1题:
After enabling port security on a Cisco Catalyst switch, what is the default action when the configuredmaximum of allowed MAC addresses value is exceeded?()
第2题:
When you enter the interface command auto qos voip cisco-phone on a port at the edge of a network,how does the Cisco Catalyst switch detect if a Cisco IP Phone is connected to the port?()
第3题:
A. isolated mode
B. switchport mode
C. modular mode
D. community mode
E. promiscuous mode
F. global mode
第4题:
Which two of the following statements describe a routed switch port on a multilayer switch?()
第5题:
You are configuring a Cisco multilayer switch for the Company network. Which command would you use to configure a port to act as a routed interface?()
第6题:
In the Cisco FabricPath domain, one switch becomes the root for the multidestination tree. Cisco FabricPath switches compare which three parameters to select the root? ()
第7题:
When creating a role in a Cisco Nexus 7000 Series Switch, rules are used to define the type of operations that a role will allow the user to perform. Which two of these parameters cannot be applied as a rule? ()
第8题:
A. is olated mode
B. switchport mode
C. modular mode
D. community mode
E. promiscuous mode
F. global mode
第9题:
Which three of these pre-requisite for resetting a Catalyst Express 500 switch when Cisco Network Assistant is unavailable?()
第10题:
You work as a network Technician. A new workstation has consistently been unable to obtain anIP address from the DHCP server when the workstation boots. Older workstations function normally, and the new workstation obtains an address when manually forced to renew its address. What should be configured on the switch to allow the workstation to obtain an IP address at boot?()