An IP address is required on the physical interface of the central router.
All routers are required to be fully meshed.
All routers must be in the same subnet to forward routing updates and broadcasts.
Multipoint is the default configuration for Frame Relay subinterfaces.
第1题:
A. frame-relay arp
B. frame-relay map
C. frame-relay interface-dlci
D. frame-relay lmi-type
E. frame-relay pvc
第2题:
A.show frame-relay map
B.show frame-relay lmi
C.show inter serial
D.show frame-relay pvc
第3题:
A. frame-relay arp
B. frame-relay map
C. frame-relay interface-dlci
D. frame-relay lmi-type
第4题:
A new frame-relay network is being implemented and inverse ARP does not appear to be operating correctly. Which alternative command can be used to provide connectivity?()
第5题:
Which of the following Frame-Relay encapsulation commands would you use, if you had to connect your Cisco router to a non-Cisco router?()
第6题:
A. The local DLCI on each subinterface of the Frame Relay.
B. The Frame Relay encapsulation on the physical interface.
C. An IP address on the physical interface.
D. The subinterface type as point-to-point
第7题:
A.show frame-relay end-to-end
B.show frame-relay map
C.show frame-relay lmi
D.show frame-relay pvc
第8题:
A. EIA/TIA
B. Q.932
C. Q.933A
D. IEEE
E. Cisco
F. Annex D
第9题:
Which statement about Frame Relay is not true?()
第10题:
A new frame relay connection is being brought up. Which of the following are frame relay LMI type options that can be configured on this new link?()