It is a route to be used when the routing protocol fails.
It is a route configured by an ISP that sends traffic into a corporate network.
It is a route used when a packet is destined for a remote network that is not listed in the routing table.
It is a route manually configured for a specific remote network for which a routing protocol is not configured.
It is used to send traffic to a stub network.
第1题：
A. Define the virtual router IP address on both WXC devices.
B. Add a static route for the virtual router IP address on both WXC devices.
C. Define the physical IP address of each router on each respective WXC device.
D. Leave the default gateway field in the WXC device blank; it will automatically detect the active gateway address.
第2题：
A. It is a route to be used when the routing protocol fails.
B. It is a route configured by an ISP that sends traffic into a corporate network.
C. It is a route used when a packet is destined for a remote network that is not listed in the routing table.
D. It is a route manually configured for a specific remote network for which a routing protocol is not configured.
E. It is used to send traffic to a stub network.
第3题：
A. resolve
B. indirect
C. next-hop
D. recursive
第4题：
A router learns about a remote network from EIGRP, OSPF, and a static route. Assuming all routing protocols are using their default administrative distance, which route will the router use to forward data to the remote network（）。
第5题：
A router learns about a remote network from EIGRP, OSPF, and a static route. Assuming all routing protocols are using their default administrative distance, which route will the router use to forward data to the remote network（）。
A.The router will use the static route.
B.The router will use the OSPF route.
C.The router will use the EIGRP route.
D.The router will load balance and use all three routes.
第6题：
Refer to the exhibit. R1 accesses the Internet using E0/0. You have been asked to co nfigure R1 so that a default route is generated to its downstream devices (191.0.0.1 and 192.0.0.1). Which commands would create this configuration? （）
A.router eigrp 190redistribute static ! ip route 0.0.0.0 0.0.0.0 Null0
B.ip default - network 2 0.0.0.0
C.router eigrp 190 redistribute static ! ip route 0.0.0.0 255.255.255.255 Null0
D.ip default - network 20.20.20.0
第7题：
A.When manual summarization is configured, the router immediately creates a route that points to null0 interface
B.Manual route summarization is configured in router configuration mode when the router is configured for EIGRP routing
C.Manual route summarization is configured on the interface
D.The ip summary - address eigrp command generates a default route with an administrative distance of 5
E.When manual summarization is configured, the summary route will use the metric of the largest specific metric of the summary routes
F.The ip summary - address eigrp command generates a default route with an administrative distance of 90
第8题：
A. incorrect DSL network redistribution
B. incorrect static host route configuration
C. incorrect static customer route configuration
D. incorrect default static route configuration on the end user
第9题：
The following configuration command was issued on router TK1:ip route 172.16.3.0 255.255.255.0 192.168.2.1.Which of the following statements are true regarding this command?（）
第10题：
Which of the following commands would you use, to configure a default route to any destination NOT found in the routing table?（）