Which two loopback types are supported for serial interfaces

题目
多选题
Which two loopback types are supported for serial interfaces on Juniper devices?()
A

Local

B

Far End

C

Remote

D

Bidirectional

如果没有搜索结果或未解决您的问题,请直接 联系老师 获取答案。
相似问题和答案

第1题:

There is a connectivity problem between the serial 0/0 interface of router TESTKING1 and the serial 0/0 interface of TESTKING2. A leased line point to point circuit is installed between these two routers. The output from the "show interface serial 0/0" command is displayed below for each of these routers:From your observations of the above exhibit, what is the underlying cause of the problem?()

A. The loopback is not set.

B. The serial cable is faulty.

C. The subnet mask is not configured properly.

D. The IP address is not configured properly.

E. The Layer 2 frame types are not compatible.

F. The keepalive setting is not configured properly.


参考答案:E

第2题:

Which command can be used to determine the type of cable attached to the Serial 0/0 interface on a router?()

  • A、show interfaces serial 0/0
  • B、show running-config
  • C、show version
  • D、show controllers serial 0/0
  • E、show ip interface
  • F、show line serial 0/0

正确答案:D

第3题:

Which two loopback types are supported for serial interfaces on Juniper devices?()

A.Local

B.Far End

C.Remote

D.Bidirectional


参考答案:A, C

第4题:

On a 3550 EMI switch,  which three types of interfaces can be used to configure HSRP? ()

  • A、 Loopback interface
  • B、 SVI interfac
  • C、 Routed port
  • D、 Access port
  • E、 EtherChannel port channel
  • F、 BVI interface

正确答案:B,C,E

第5题:

Which of the following tools should Mike, a technician, use when testing a serial port?()

  • A、Cable tester
  • B、Multimeter
  • C、Loopback plug
  • D、Logic probe

正确答案:C

第6题:

Which two Cisco AutoQoS configuration statements are true? ()

  • A、the auto discovery qos command is supported on serial interfaces, subinterfaces, and virtual interfaces
  • B、CEF must be enabled before configuring the auto discovery qos command
  • C、the auto discovery qos privilege EXEC command must be configured on a router for several days to collect a sampling of data traffic
  • D、the auto qos trust command relies on NBAR to provide VoIP classification
  • E、the auto qos voip command configures the voip classification on routers and switches

正确答案:B,E

第7题:

Based on the following items, which two types of interfaces are found on all network-based IPS sensors?()

  • A、Loopback interface
  • B、Command and control interface
  • C、Monitoring interface
  • D、Management interface

正确答案:B,C

第8题:

Which two media types support asynchronous transfer mode?()

A.T3

B.SONET

C.Gigabit-Ethernet

D.EIA/TIA-232 serial


参考答案:A, B

第9题:

You have just purchased a new Cisco 3560 switch running the enhanced IOS and need configure  it to be installed in a high availability network. On a 3560 EMI switch,  which three types of  interfaces can be used to configure HSRP?()

  • A、 SVI interface
  • B、 Access port
  • C、 EtherChannel port channel
  • D、 Loopback interface
  • E、 Routed port
  • F、 BVI interface

正确答案:A,C,E

第10题:

Which three statements about anycast RP are true? ()

  • A、MSDP is running between anycast RPs
  • B、Anycast RP provides redundancy and load-sharing capabilities
  • C、Multicast BGP is running between anycast RPs
  • D、In anycast RP,two or more RPs are configured with the same multicast IP address on loopback interfaces
  • E、In anycast RP,two or more RPs are configured with the same unicast IP address on loopback interfaces

正确答案:A,B,E

更多相关问题