Which IOS command would you enter if you wanted to view a list of IBGP and EBGP neighbor relationships that are configured（）
第1题：
A.show ip ospf
B.show ip route
C.show ip protocols
D.show ip ospf database
E.None of the other alternatives apply
第2题：
You are trying to deploy a configuration job to an ios access point using the wlse， but the job fails. Which of the following would cause this failure？（）
第3题：
A.show interfaces brief
B.show interfaces status
C.show ip interface brief
D.show interfaces terse
第4题：
Which command would you configure globally on a Cisco router that would allow you to view directly connected Cisco devices?（）
第5题：
Which IOS command would you enter if you wanted to view a list of IBGP and EBGP neighborrelationships that are configured？（）
第6题：
A. enable cdp
B. cdp enable
C. cdp run
D. run cdp
第7题：
Which IOS command would you use to find out which networks are routed by a particular OSPFprocess？（）
第8题：
A.show ip bgp
B.show ipbgp paths
C.show ipbgp peers
D.show ipbgp summary
E.show ipbgp protocols
第9题：
At which command prompt would you issue the set date
第10题：
After working on a router, some problems arise and you wish to view the commands that you recently entered. Which IOS command opens the history buffer and displays the most recently entered commands?（）