Refer to the exhibit. For what t

题目

Refer to the exhibit. For what two reasons has the router loaded its IOS image from the location that is shown? ()

  • A、Router1 has specific boot system command that instruct it to load IOS from TFTP server.
  • B、Router1 is acting as a TFTP server for other routers.
  • C、Router1 cannot locate a valid IOS image in flash memory.
  • D、Router1 defaulted to ROMMON mode and loaded the IOS image from a TFTP server.
  • E、Cisco routers will first attempt to load a image from TFTP for management purposes.
如果没有搜索结果或未解决您的问题,请直接 联系老师 获取答案。
相似问题和答案

第1题:

Refer to the exhibit. Which command would verify if PBR reacts to packets sourced from 172.16.0.0/16?()

A. show ip route

B. show policy - map

C. show access - lists

D. show route - map


参考答案:D

第2题:

Refer to the exhibit. What is required to complete the IPv6 routing configurations shown?()

A. Interface authentication must be configured

B. The routing processes must be configured with an area ID

C. IP unicast routing must be enabled

D. IPv4 ad dresses must be applied to the interfaces


参考答案:C

第3题:

Refer to the exhibit. The routing protocols EIGRP and OSPF have been configured as indicated in the exhibit. Given the partial configuration of router R2, which network will be present in th e routing table of R4?()

A. Network B

B. Network A and Network B

C. Network A

D. neither Network A nor Network B


参考答案:A

第4题:

Refer to the exhibit. Router RT - 1 and router RT - 2 both advertise network 131.25.0.0/16 to routerRT - 3 via internal BGP. What is the reason that router RT - 3 chose router RT - 1 as its best path tonetwork 131.25.0.0/16.()

A. It has a better router ID

B. It advertises a lower autonomous system

C. It advertises t he best AS - path

D. It advertises the best local preference

E. It advertises the best origin code

F. It advertises the best MED


参考答案:A

第5题:

Refer to the exhibit. On the basis of the output, what two conclusions can be reached?()

A. The default administrative distance has been changed.

B. IS - IS is not enabled.

C. Three physical interfaces are taking part in integrated IS - IS.

D. IS - IS is not redistributing any oth er routing protocols.

E. There are two neighboring routers sending IS - IS routing information.

F. Address summarization is configured.


参考答案:D, E

第6题:

Refer to the exhibit. Based on this command output, what can we conclude about R3?()

A. R3 is an ABR.

B. R3 is not connec ted to the backbone.

C. R3 has four neighbors.

D. R3 is the DR for area 2.


参考答案:A

第7题:

Refer to the parti al configurations in the exhibit. What address is utilized for DR and BDR identification on Router1?()

A. the serial 1/1 address

B. the serial 2/0 address

C. a randomly generated internal address

D. the configured router - id address


参考答案:D

第8题:

Refer to the exhibit. What must be done on router RTA to ensure that EIGRP works effectively in a Frame Relay multipoint environment?()

A. Issue the command bandwidth 224 on the physical interface.

B. Issue the command bandwidth 56 on the physical interface.

C. Issue the command bandwidth 224 on each subinterface.

D. Issue the command bandwidth 56 on each subinterface.


参考答案:A

第9题:

Refer to the exhibit. By default, when RTB passes BGP advertisements from RTA about network 192.168.2.0 to RTC, what address will be listed as the next - hop address? ()

A. 10.1.1.2

B. 192.168.1.49

C. 10.1.1.1

D. 192.168.1.50


参考答案:D

第10题:

Refer to the exhibit. What is the most appropriate summarization for these routes?()

A.10.0.0.0/21

B.10.0.0.0/22

C.10.0.0.0/23

D.10.0.0.0/24


参考答案:B

更多相关问题