Your company plans on migrating their network from IPv4 to IPv6 in the near future. Which three techniques can be used to transition from IPv4 to IPv6?()A、Dual stackB、NATC、Flow labelD、Mobile IPE、6to4 tunnelingF、AnycastG、MBGP

题目

Your company plans on migrating their network from IPv4 to IPv6 in the near future. Which three techniques can be used to transition from IPv4 to IPv6?()

  • A、Dual stack
  • B、NAT
  • C、Flow label
  • D、Mobile IP
  • E、6to4 tunneling
  • F、Anycast
  • G、MBGP
如果没有搜索结果或未解决您的问题,请直接 联系老师 获取答案。
相似问题和答案

第1题:

Which two statements are true about using IPv4 and IPv6 simultaneously on a network segment? ()

A. IPv6 allows a host to create its own IPv6 address that will allow it to communicate to other devices on a network configured via DHCP. IPv4 does not provide a similar capability for hosts.

B. IPv6 provides for more host IP addresses but IPv4 provides for more network addresses.

C. Hosts can be configured to receive both IPv4 and IPv6 addresses via DHCP.

D. Host configuration options for IPv4 can be either statically assigned or assigned via DHCP.Host configuration options for IPv6 can be statically assigned only.

E. IPv4 and IPv6 addresses c an be simultaneously assigned to a host but not to a router interface.


参考答案:A, C

第2题:

the network administrator has been asked to give reasons for moving from ipv4 to ipv6. what are two valid reasons for adopting ipv6 over ipv4?()

A. telnet access does not require a password

B. nat

C. no broadcast

D. chanage of destination address in the ipv6 header

E. chanage of source address in the ipv6 header

F. autoconfiguration


参考答案:C, F

第3题:

In IPv6 network, an IPv6 overlay tunnel is required to communicate with isolated IPv6 networks across the existing IPv4 infrastructurE. There are currently fiv e IPv6 overlay tunnel types.Which three IPv6 overlay tunnel statements are true?()

A. Overlay tunnels can only be configured between border routers capable of supporting IPv4 and IPv6.

B. An manual overlay tunnel supports point - to - multipo int tunnels capable of carrying IPv6 and Connectionless Network Service (CLNS) packets.

C. Overlay tunneling encapsulates IPv6 packets in IPv4 packets for delivery across an IPv4 infrastructure.

D. Overlay tunnels can be configured between border route rs or between a border router and a host capable of supporting IPv4 and IPv6.

E. Cisco IOS supports manual, generic routing encapsulation (GRE), IPv4 - compatible, 6to4, and Intra - Site Automatic Tunnel Addressing Protocol (ISATAP) overlay tunneling mechan isms.

F. Cisco IOS supports manual, generic routing encapsulation (GRE), IPv6 - compatible, 4to6, and Multiprotocol Label Switching (MPLS) overlay tunneling mechanisms.


参考答案:C, D, E

第4题:

A company is using 6to4 tunneling within their IPv6 network. Which two statements about this kindof tunneling are accurate?()

  • A、6to4 is a manual tunnel method
  • B、Prepending a reserved IPv6 code to the hexadecimal representation of 192.168.0.1 facilitates6to4 tunneling
  • C、Each 6to4 site receives a /48 prefix in a 6to4 tunnel
  • D、2002::/48 is the address range specifically assigned to 6to4
  • E、Prepending 0x2002 with the IPv4 address creates an IPv6 address that is used in 6to4tunneling

正确答案:C,E

第5题:

Which name describes an IPV6 host-enable tunneling technique that uses IPV4 UDP,does not require dedicated gateway tunnels,and can pass through existing IPV4 NAT gateways?()

A.dual stack

B.dynamic

C.Teredo

D.Manual 6to4


参考答案:C

第6题:

Your company plans on migrating their network from IPv4 to IPv6 in the near future. Which three techniques can be used to transition from IPv4 to IPv6?()

A. Dual stack

B. NAT

C. Flow label

D. Mobile IP

E. 6to4 tunneling

F. Anycast

G. MBGP


参考答案:A, B, E

第7题:

Which three approaches can be used while migrating from an IPV4 addressing scheme to an IPV6 scheme.()

A. statically map IPV4 address to IPV6 addresses

B. configuration IPv4 tunnels between IPV6 islands

C. use DHCPv6 to map IPV4 addresses to IPV6 addresses

D. use proxying and translation to translate IPV6 packets into IPV4 packets

E. configure IPV6 directly

F. enable dual-stack routing


参考答案:A, B, F

第8题:

Which statement describes the difference between a manually configured IPv6 in IPv4 tunnel versus an automatic 6to4 tunnel?()

A. An automatic 6to4 tunnel does not req uire dual - stack (IPv4 and IPv6) routers at the tunnel endpoints.

B. An automatic 6to4 tunnel allows multiple IPv4 destinations.

C. A manually configured IPv6 in IPv4 tunnel allows multiple IPv4 destinations.

D. A manually configured IPv6 in IPv4 tunnel does not require dual- stack (IPv4 and IPv6) routers at the tunnel endpoints.


参考答案:B

第9题:

Which name describes an IPV6 host-enable tunneling technique that uses IPV4 UDP,does not require dedicated gateway tunnels,and can pass through existing IPV4 NAT gateways?()

  • A、dual stack
  • B、dynamic
  • C、Teredo
  • D、Manual 6to4

正确答案:C

第10题:

Which two statements are true about using IPv4 and IPv6 simultaneously on a network segment? ()

  • A、IPv6 allows a host to create its own IPv6 address that will allow it to communicate to other devices on a network configured via DHCP. IPv4 does not provide a similar capability for hosts.
  • B、IPv6 provides for more host IP addresses but IPv4 provides for more network addresses.
  • C、Hosts can be  configured to receive both IPv4 and IPv6 addresses via DHCP.
  • D、Host configuration options for IPv4 can be either statically assigned or assigned via DHCP.Host configuration options for IPv6 can be statically assigned only.
  • E、IPv4 and IPv6 addresses c an be simultaneously assigned to a host but not to a router interface.

正确答案:A,C

更多相关问题