The Testking router is running both RIP and IGRP, and the same route is learned by this router from both of these methods. However, when you issue the command"show ip route" you see only the IGRP route, and not the RIP route. Why is this?()
第1题:
A.config
B.clientqos.cnf
C.startup-config
D.running-configuration
第2题:
TestKing.com is configuring the serial interface of a Cisco router to connect to the router of a new ISP. A full T1 is being used for the Internet connection. After issuing the show interface serial 0/0 command, it is observed that the interface is UP and the line protocol is DOWN.Which of the following commands could fix this problem?()
A. Border# copy running-config startup-config
B. Border(config)# no shutdown
C. Border(config-if)# encapsulation ppp
D. Border(config-if)# no cdp enable
E. Border(config-if)# ip routing
第3题:
要显示路由器的运行配置,下面的路由器命令中,哪一条是正确的?——
A.Router#show running—config
B.Router#show startup—config
C.Router‘#show configuration
D.Router>show running—config
第4题:
A.The loopback addresses are on different subnets
B.The value of the dead timers on the router are different
C.Route summarization is enabled on both routers
D.The process indentifier on router A is different than the process identifier on router B
第5题:
TestKing.com has a large corporate network that uses multiple routing protocols.Hosts in a portion of the network that uses EIGRP have become unreachable.Which router command will allow you, the network technician, to view the status of these routes?()
A. TestKing# show eigrp entries
B. TestKing# show protocols
C. TestKing# debug eigrp routes
D. TestKing# show ip route eigrp
E. TestKing# show route eigrp
第6题:
A technician at TestKing needs to update the network documentation. One of the tasks includes documenting the name of the IOS image file of each router in the network.Which commands could be used to find this information?()
A. Router# show protocols
B. Router# show version
C. Router# show image
D. Router# show IOS
E. Router# show flash
第7题:
A. TestKing# show ip route *
B. TestKing# debug eigrp route
C. TestKing# debug ip eigrp
D. TestKing# debug ip protocols eigrp
E. TestKing# show ip route eigrp
第8题:
清空某台Cisco路由器NVRAM中的全部配置信息,正确的配置操作是______。
A.Router(config)#clear running-config
B.Router#wirte erase
C.Router(config)#erase running-config
D.Router#erase running-config
第9题:
The TestKing.com administrator has made changes to the router configuration but cannot remember if those changes were saved. Which of the following commands allows the administrator to see the configuration that will load when the router is restarted?()
A. TestKingC# show memory
B. TestKingC# show startup-config
C. TestKingC# show running-config
D. TestKingC# show restart
第10题: