When the BGP path selection process is being performed on a Cisco router, which BGP attribute is used first when determining the best path?（）
第1题：
A. Both are configured as type external.
B. Both configurations use the peer-as command.
C. Neither advertises the local-preference attribute.
D. Both set next-hop self when advertising routes to peers.
E. Both modify the AS-path attribute when advertising routes.
第2题：
A.IVR
B.VoQ
C.FSPF
D.VSANs
E.SANTap
第3题：
A. set protocols bgp group mygroup path-selection cisco-non-deterministic;
B. set protocols bgp group i-bgp no-aggregator-id;
C. set protocols bgp group mygroup no-client-reflect;
D. set protocols bgp group i-bgp damping;
第4题：
What are the mandatory， well-known BGP attributes？（）
第5题：
A.route-policy
B.ip-prefix
C.as-path-filter
D.community-filter
第6题：
A. local preference
B. MED
C. weight
D. or igin
E. next - hop
F. AS - path
第7题：
A.只有包含community100：1或者as-path为100的BGP路由才会通过route-policy test，并将AS-PATH改为200
B.只有包含community100：1并且as-path为100的BGP路由才会通过route-policy test，并将AS-path改为200
C.只有community为100：1并且AS-PATH为100的BGP路由才会通过route-policy test，并将AS-PATH改为200
D.Community为100：1并且AS-PATH为100的BGP路由会通过route-policy test，并将AS-PATH改为200
第8题：
Given the following LSP configuration, which statement is true?（）label-switched-path lsp-xyz { to 10.200.1.1; primary path1; secondary path2; secondary path3; no-cspf; } path path1 { 10.200.10.1 strict; } path path2 { 10.200.20.1 strict; } path path3 { 10.200.30.1 loose; }
A. The router will use path1 when it is available and stable.
B. The router will use path3 when it is available and stable.
C. The router will attempt to establish path2 only when path1 and path3 are down.
D. The router will attempt to establish path1 only when path2 and path3 are down.
第9题：
What best explains the BGP route-reflector function？（）
第10题：
BGP best route selection process is based on what ？（）