An administrator issued a command to update the firmware of an Ethernet adapter on a partitioned system， but received an error. What is the most likely cause of the problem？（）
第1题：
A. IS-IS, EIGRP, SSO, BGP
B. ISSU, OSPF, IS-IS
C. IETF, OSPF, ISSU
D. EIGRP, BGP, OSPF, IS-IS
第2题：
What tasks can only be performed in the default or admin VDC？（）
第3题：
An administrator is experiencing availability issues on a Linux server. The administrator decides tocheck the server for an IP address conflict on the server. Which of the following commands should the administrator use?（）
A.traceroute
B.tracert
C.ifconfig
D.ipconfig
第4题：
As an experienced Network Engineer, you are responsible for network connectivity and system configuration. Which of the following protocols will be supported by Cisco Nonstop Forwarding (NSF)?（）
第5题：
Windows默认帐户应如何管理（）
第6题：
Which statement best describes ACL configuration using configuration session mode on Cisco Nexus switches？（）
第7题：
In a Cisco Nexus 7000 platform configured with GLBP， which GLBP timer can be tuned to prevent unnecessary GLBP state changes during a switchover or ISSU？（）
第8题：
An administrator is using a protocol analyzer to monitor traffic between two servers. However, theonly traffic that appears is broadcast and traffic originating from the administrator‘s PC.Which of the following devices is the administrator plugged into? （）
A.Hub
B. Bridge
C. Switch
D. Router
第9题：
Which protocols does Cisco NSF support? （）
第10题：
An administrator attempts to install the latest security patches for an older server. When the administrator runs the patch installer， the install fails. The administrator tries again， and the installer fails again. Which of the following is the MOST likely reason for this？（）