A server has been having a memory problem. What feature can be used to determine the failing memory module？（）A、Reboot the serverB、RSA IIC、LightPath DiagnosticsD、ServerGuide

第1题：

After applying a new ACL on a device， its CPU utilization rose significantly and many messages startingwith "%SEC-6-IPACCESSLOG" appeared on the Syslog server.What can be done to resolve this situation？（）

• A、Increase memory allocation for ACLs.
• B、Remove all entries from the ACL and use a single permit ip any any statement.
• C、Remove the log keyword from each ACL entry.
• D、Reboot the device after the ACL has been applied.

第2题：

What are two benefits of the modular design of the Junos OS?（）

• A、Each module uses application-specific integrated circuits (ASICs).
• B、Each module runs in its own protected memory space.
• C、Each module can be individually restarted.
• D、Each module is supported across all Junos platforms.

第3题：

第4题：

The technician is repairing a PC which appears to have a failing RAM module. After replacing the module, the extra memory still is not registering. Which of the following is MOST likely the issue?（）

• A、Jumper settings are incorrect
• B、The RAM module is defective
• C、The memory slot is defective
• D、CMOS needs to be flashed

第5题：

A technician has to populate a server motherboard with memory. The board has a memory bus speed of 800 MHz. Which of the following memory types should be used？（）

• A、DDR3
• B、SDRAM
• C、DDR
• D、DDR2

第6题：

AIX 5L and SUN Solaris have differing approaches at handling processor failures. Which statement best describes how AIX handles processor failures？（）

• A、If AIX discovers a processor with too many recoverable errors during runtime， it will dynamically turn off that processor， while the rest of the system keeps running.
• B、If AIX detects a failing processor it will automatically move all resources to another processor. The failed processor can be hot-swapped and the new replacement becomes the active processor.
• C、If AIX determines a processor is failing， it will perform diagnostics to determine which processor function can be disabled and dynamically reallocate all CPU and memory resources thus isolating the failure condition and preventing a reboot.
• D、If AIX senses a processor level error condition， internal diagnostics are activated to determine the severity of the problem. After the failure threshold is met， a message is broadcast to the service processor informing the operator to perform a system reboot.

第7题：

An administrator is adding additional memory into a server that registers 1GB of memory in the OS and notices that the system has 2GB of memory physically installed； however， the server only shows 1GB of memory during POST.  Which of the following is the MOST likely reason for this？（）

• A、 The OS does not support more than 1GB of memory.
• B、 The system memory has different manufacture dates.
• C、 Two of the memory sticks are defective.
• D、 The server is using memory interleaving.

第8题：

When enabling IPS on an ISR using the Cisco SDM IPS Wizard， in what location can the SDF be placed？（）

• A、On the RAM of the ISR
• B、On the USB memory stick of the ISR
• C、On the NVRAM of the ISR
• D、On the IPS Module of the ISR
• E、On the Flash memory of the ISR

第9题：

Which of the following does an out-of-memory error indicate on a printer?（）

• A、A faulty memory module in the printer.
• B、A postscript print job has been sent to the printer.
• C、A large print job has been sent to the printer.
• D、The printer firmware needs to be updated.

第10题：

The administrator has just installed a new memory module into the server. Now， the server is not showing the new memory. Which of the following should the administrator perform FIRST？（）

• A、System reboot
• B、Reseat the memory
• C、Install the latest firmware
• D、Install the latest driver