Which default JUNOS software routing table contains IPv6 unicast routes？（）
第1题：
By default, which character indicates the UNIX shell prompt?（）
第2题：
Which of the following uses port 110 by default?（）
第3题：
A. load factory-default
B. load override factory-default
C. load replace default
D. load set default
第4题：
The default constructor initializes method variables.
The compiler always creates a default constructor for every class.
The default constructor invokes the no-parameter constructor of the superclass.
The default constructor initializes the instance variables declared in the class.
When a class has only constructors with parameters， the compiler does not create a default constructor.
第5题：
You navigate to "UAC" > "Infranet Enforcer" > "Auth Table Mapping" in the admin GUI. You see one policy, which is the unmodified, original default policy.Which statement is true?（）
第6题：
Which routing protocol by default uses bandwidth and delay as metrics（）。
第7题：
Which of the following protocols uses port 119, by default?（）
第8题：
Which two statements are true regarding the creation of a default constructor？（）
第9题：
Switch(config)# ip default-network 192.168.12.1
Switch(config)#ip route-default 192.168.12.1
Switch(config)# ip default-gateway 192.168.12.1
Swicth(config)# ip route 192.168.12.1 0.0.0.0
第10题：
Dynamic auth table mapping is not enabled.
A successful authentication attempt will result in a new authentication table entry, which will be delivered only to the Junos enforcer protecting the network from which the user has authenticated.
To create a static auth table mapping, you must delete the default policy.
The default policy applies only to the factory-default role User.