You enter configuration mode with the configure command. You need to abort the changes that you have made and start again with a fresh copy of the active configuration. Which command should you use?()
第1题:
A. set
B. copy candidate active
C. apply-config
D. commit
第2题:
A. enable
B. configure
C. edit
D. cli
第3题:
What will cause a Ezonexam router to enter setup mode? (Choose two)
A. The configuration file is missing in NVRAM.
B. The configuration register is set to 0x2100.
C. Boot system commands are misconfigured in the running-configuration.
D. The setup command was issued from the privileged mode prompt.
E. The IOS is missing.
F. The IOS is corrupt.
第4题:
A network administrator changes the configuration register to 0x2142 and reboots the router. What are two results of making this change?()
第5题:
A. The IOS image will be ignored.
B. The router will prompt to enter initial configuration mode.
C. The router will boot to ROM.
D. Any configuration entries in NVRAM will be ignored.
E. The configuration in flash memory will be booted.
第6题:
A. exit
B. configure
C. edit
D. cli
第7题:
Refer to the exhibit. A network administrator wants to reduce the number of OSPF routes advertised from Area 1 into Area 2. As the router configuration specialist, what two things would you do to accomplish this goal?()
A. Enter the configuration on router B1.
B. Enter the configuration on router B4.
C. On the same router, enter the Summary - address 10.10.1.0 255.255.255.128 subcommand.
D. On the same router, enter the Area 1 range 10.10.1.0 255.255.255.128 subcommand.
E. On the same ro uter, enter the Area 2 range 10.10.1.0 255.255.255.128 subcommand.
第8题:
A. enable mode
B. configuration mode
C. operational mode
D. active mode
第9题:
You are a senior network administrator at TestKing, and while performing thepassword recovery procedure on your 2500 series Cisco router, you type in thefollowing command:o/r 0x2142What is the purpose of this command?()
第10题:
Exhibit: The following are true with one of the TestKing routers: 1) The IOS image in flash is missing 2) No Network connectivity is available. 3) The router fallback IOS image is corrupt. How will this Cisco 2600 series router respond if the conditions listed in the exhibit exist during the boot process?()