Which statement is true about configuring a back-to-back connection frame-relay on Juniper Routers?（）
第1题：
A. A system log message is generated, confirming the transfer attempt.
B. The destination filename format can be altered by configuration.
C. The frequency the system archives the configuration cannot be changed.
D. An archive log is created to track transfer attempts, both failed and successful.
第2题：
A.Both DTE and DCE will send keep-alives by default so no special configuration is required.
B.The circuit is negotiated automatically so no special configuration is required.
C.All equipment is by default DTE, one side should be set to DCE
D.All equipment is by default DCE, one side should be set to DTE
第3题：
A、It offers help to homeless people.
B、It has nothing special.
C、I like working here.
第4题：
A. It uses SNMP v1.
B. It scans devices for hardware information.
C. It scans and records the operational status of devices.
D. When the configuration of a device changes, the inventory is automatically updated.
第5题：
A. RTA will not establish an OSPF adjacency w ith RTB
B. RTA will send OSPF hello packets, but will not send OSPF updates
C. RTA will not accept OSPF hello packets from RTB
D. RTA will send OSPF updates, but will not establish an adjacency with RTB
第6题：
A. A system log message is generated, confirmed the transfer attempt
B. The destination filename format can be altered by configuration
C. The frequency the system archives the configuration cannot be changed
D. An archive log is created to track transfer attempts both failed and successfull
第7题：
A. The edge routers can use any locally configured IPv6 address.
B. Hosts and routers inside a 6to4 site will need a special code.
C. An edge router must use IPv6 address of 2002::/16 in its prefix.
D. IPv4 traffic is encapsulated with an IPv6 header.
第8题：
A. J-series routers are accessible by default.
B. M7i and M10i routers are accessible by default.
C. You need to install a license before accessing a J-series router.
D. You need to enable the HTTP service on M7i, M10i, and J-series routers before accessing them.
第9题：
A. Router(config-if)# encapsulation frame-relay q933a
B. Router(config-if)# encapsulation frame-relay ansi
C. Router(config-if)# encapsulation frame-relay ietf
D. Router(config-if)# encapsulation frame-relay isl
E. None of the above
第10题：
A network administrator needs to configure a router for a Frame Relay connection to a non-Cisco router. Which of the following commands will prepare the WAN interface for this connection?（）