What is the default route preference value for EBGP?()
第1题:
A. 5 minutes
B. 30 minutes
C. 60 minutes
D. 90 minutes
第2题:
A.The route is rejected.
B.The route is accepted.
C.The route is given a lower priority.
D.The route is sent to the default policy.
第3题:
You need to configure a default route on a Ezonexam router. Which command will configure a default route on a router?
A.VE1(config)# ip route 0.0.0.0 10.1.1.0 10.1.1.1
B.VE1(config)# ip default-route 10.1.1.0
C.VE1(config)# ip default-gateway 10.1.1.0
D.VE1(config)# ip route 0.0.0.0 0.0.0.0 10.1.1.1
第4题:
A. It is a route to be used when the routing protocol fails.
B. It is a route configured by an ISP that sends traffic into a corporate network.
C. It is a route used when a packet is destined for a remote network that is not listed in the routing table.
D. It is a route manually configured for a specific remote network for which a routing protocol is not configured.
E. It is used to send traffic to a stub network.
第5题:
A system is experiencing packet routing problems,when the administrator runs ‘netstat -nr‘ the following default routes are displayed: default165.253.251.1UG51601304 en8--default 192.168.50.1UGH01590450 en4-- Assuming the first route is correct.How can the administrator remove the incorrect default route?()
A.route delete default 192.168.50.1
B.access smit with the route_remove shortcut
C.chdev -l inet0 -a delroute=net,-hopcount,0,,192.168.50.1
D.flush the routing table from the console and configuring the 165.253.251.1 route
第6题:
A. Traffic matching the default route will use 10.1.1.1 as the next hop.
B. Traffic matching the default route will use 10.1.1.254 as the next hop.
C. Traffic matching the default route will be load-balanced per packet across both next hops.
D. Traffic matching the default route will be load-balanced per flow across both next hops.
第7题:
A.The route is a direct route.
B.The route was selected as active.
C.The route is a default route.
D.The route was learned using a dynamic routing protocol.
第8题:
A.0
B.5
C.10
D.170
第9题:
A.The last default - network statement will always be preferred.
B.A route to the 140.140.0.0 network does not exist in the routing table.
C.Default - network selection will always prefer the statement with the lowest IP address.
D.A router will load balance across multiple default - networks; repeatedly issuing the show ip route command would show the gateway of last resort changing between the two networks.
第10题:
A. R4(config)# ip route 0.0.0.0 0.0.0.0 10.1.1.1
B. R4(config)# ip default - network 10.0.0.0
C. R4(config - router)# default -information originate
D. R4(conf ig)# ip route 10.0.0.0 255.0.0.0 10.1.1.1