changing the default policy map from a default MTU of 1500 to 9216
using the command system jumbomtu 9216
using the command interface MTU 9216
configuring the default Ethernet system class to an MTU of 9216 with a new network QoS policy map
第1题:
When creating a role in a Cisco Nexus 7000 Series Switch, rules are used to define the type of operations that a role will allow the user to perform. Which two of these parameters cannot be applied as a rule? ()
第2题:
Enabling jumbo frame support on a Cisco Nexus 5500 Switch can be done through which method?()
第3题:
A Ezonexam Ethernet switch receives a unicast frame. with a destination MAC that is listed in the switch table. What will this switch do with the frame?
A. The switch will forward the frame. to a specific port
B. The switch will forward the frame. to all ports except the port on which it was received
C. The switch will return a copy of the frame. out the source port
D. The switch will not forward unicast frames
E. The switch will remove the destination MAC from the switch table
F. None of the above.
第4题:
Which attribute is used to pass the user role back to the Nexus when remote AAA is enabled?()
第5题:
Which three capabilities make the Cisco Nexus 7010 switch an effective solution for the data center core? ()
第6题:
Which Cisco product performs virtualized Ethernet switching within a VMware ESX host?()
第7题:
Which three statements best describe multicast operation on Cisco Nexus switches in a data center?()
第8题:
Which of following VLAN frame encapsulation types are configurable on a Cisco switch?()
第9题:
If an enterprise customer required A switch for their branch office access layer, which family of switches would the customer likely choose from?()
第10题:
A cisco aironet 1020 controller-based access point has been connected to a catalyst 3550-24 pwr switch. however, when it is powered up, the access point fails. What has caused this problem?()