Learn
Speak
Standby
Listen
Active
Remove
第1题：
Refer to the e xhibit. It is desired to set up a BGP neighbor relationship between routers R1 and R4. BGP packets between them could travel through R2 or R3. What is the simplest configuration that will allow for failover?（）
A. Configure BGP n eighbor relationships between all interfaces on R1 and R4.
B. Install a direct connection between R1 and R4.
C. Configure loopback interfaces on R1 and R4 to provide the update source address for BGP packets.
D. Configure only one neighbor relationship between R1‘s 192.168.1.2 interface and R4‘s 172.16.10.2 interface.
第2题：
Channel 13（156．65 MHz），the designated bridge-to-bridge channel，may NOT be used to ______．
A.exchange navigational information between vessels
B.exchange navigational information between a vessel and a shore station
C.conduct necessary tests
D.exchange operating schedules with company dispatcher
第3题：
They work in the same company and they are()with each other.
A. good
B. familiar
C. interested
第4题：
Router R1 is configured for HSRP. Which of the following are valid HSRP states on R1？ （）
第5题：
HSRP has been configured between two Company devices. Which of the following describe reasons for deploying HSRP？ （）
第6题：
Refer to the exhibit. Autonomous systems 200 and 300 have EBGP sessions established with their directly connected routers in au tonomous system 100. IGP has been configured on all routers in autonomous system 100 and they successfully exchange routing updates. Traffic originated in autonomous system 200 cannot reach the destination autonomous system 300. What configuration shoul d be done on the routers in autonomous system 100 in order for the traffic coming from autonomous system 200 to be forwarded to autonomous system 300?（）
A. IBGP session must be established between routers R1 R2 and R2 R3, and the synchronization must be turned off.
B. IBGP speakers within autonomous 100 must be fully meshed, and the synchronization must be turned on.
C. IBGP session must be established between routers R1 R2 and R2 R3, and the synchronization must be turned on.
D. IBGP session mu st be established between routers R1 and R3, and the synchronization must be turned off.
E. IBGP speakers within autonomous 100 must be fully meshed, and the synchronization must be turned off.
F. IBGP session must be established between routers R1 and R3, and the synchronization must be turned on.
第7题：
You administer a network that uses two routers， R1 and R2， configured as an HSRP group to provide redundancy for the gateway. Router R1 is the active router and has been configured as follows： R1#configure terminal R1（config）#interface fa0/0 R1（config-if）#ip address 10.10.0.5 255.255.255.0 R1（config-if）#standby 1 priority 150 R1（config-if）#standby preempt delay minimum 50 R1（config-if）#standby 1 track interface fa0/2 15 R1（config-if）#standby 1 ip 10.10.0.20 Which of the following describes the effect the standby preempt delay minimum 50 command will have on router R1？（）
第8题：
They usually go for a walk in ______ with each other after supper.
A、line
B、pace
C、time
D、company
第9题：
HSRP is being set up between two Company devices. In what three states is it possible for an HSRP router to be in？（）
第10题：
The LWAPP （Lightweight Access Point Protocol） is in use within the Company wireless LAN. Which statement is true about this protocol？（）