ip sla monitor low-memory
ip sla group schedule
ip sla reaction-trigger
ip sla enable timestamp
第1题:
A.When manual summarization is configured, the router immediately creates a route that points to null0 interface
B.Manual route summarization is configured in router configuration mode when the router is configured for EIGRP routing
C.Manual route summarization is configured on the interface
D.The ip summary - address eigrp command generates a default route with an administrative distance of 5
E.When manual summarization is configured, the summary route will use the metric of the largest specific metric of the summary routes
F.The ip summary - address eigrp command generates a default route with an administrative distance of 90
第2题:
A.The subnet mask in use is 255.255.255.192.
B.The subnet mask in use is 255.255.255.128.
C.The IP address 172.16.1.25 can be assigned to hosts in VLAN1
D.The IP address 172.16.1.205 can be assigned to hosts in VLAN1
E.The LAN interface of the router is configured with one IP address.
F.The LAN interface of the router is configured with multiple IP addresses.
第3题:
The following configuration commands exist only in an implementation plan document. An engineer does a copy/paste of these commands into configuration mode on Router R1. Which of the following answers is m ost accurate regarding the results?()ip sla1icmp - echo 1.1.1.1 source -ip 2.2.2.2ip sla schedule 1 start - time now life forever
A. The SLA operation will be configured but will not start until additional commands are used
B. The SLA operation is not comp letely configured so it will not collect any datA
C. The SLA operation is complete and working, collecting data into the RTTMON MIB
D. The SLA operation is complete and working but will not store the data in the RTTMON MIB without more configuration
第4题:
Which of these statements accurately identifies how Unicast Reverse Path Forwarding can be employed to prevent the use of malformed or forged IP sources addresses?()
第5题:
If all OSPF routers in a single area are configured with the same priority value,what value dose a router use for the ODPF router ID in the absence of a loopback interface?()
第6题:
A. the IP address of the first Fast Ethernet interface
B. the IP address of the console management interface
C. the highest IP address among its active interfaces
D. the lowest IP address among its active interfaces
E. the priority value until a loopback interface is configured
第7题:
How many IP addresses can be configured in a given interface?()
第8题:
Refer to the exhibit. Two routers are connected by Frame Relay and are running OSPF bet ween them. Each router has been configured with the appropriate network statements under router ospf 1, but the routers are not forming an adjacency. Which of the following three commands could be configured on each router to correct this problem?()
A. RouterC(config - if)#ip ospf network broadcast RouterD(config - if)#ip ospf network broadcast
B. RouterC(config - if)#ip ospf network point - to - point RouterD(config - if)#ip ospf network point - to - point
C. RouterC(config - router)#neighbor 10.100. 100.4 RouterD(config - router)#neighbor 10.100.100.3
D. RouterC(config - router)#neighbor 10.255.255.254 RouterD(config - router)#neighbor 10.255.255.253
第9题:
Which of these is a benefit of ESM?()
第10题:
Hosts on the same VLAN can communicate with each other but are unable to communicate with hosts on different VLANs. What is needed to allow communication between VLANs()。