switchport access vlan vlan-id
switchport
switchport mode access
no switchport
None of the other alternatives apply
第1题：
You have a computer that runs Windows Vista.You need to configure the computer to meet the following requirements:·You must be able to make configuration changes remotely.·You must be able to make the changes without the permission of the locally logged-on user.What should you do?（）
A.A
B.B
C.C
D.D
第2题：
After making changes to the router, you issue the "copy running-config startup-config" command to save changes. After reloading the router, the router comes up in setup mode. You again make changes, save them, and reboot. Again,the router comes up in setup mode.What is the most likely cause of this?（）
A. The NVRAM is corrupted.
B. The boot system commands were omitted in the configuration.
C. The configuration register setting is incorrect.
D. The upgraded configuration incompatible with the hardware platform.
E. The upgraded IOS incompatible with the hardware.
第3题：
A. enable mode
B. configuration mode
C. operational mode
D. active mode
第4题：
Which of these is true regarding the configuration and application of port access control lists？ （）
第5题：
After making changes to the router, you issue the "copy running-config startup-config" command to save changes. After reloading the router, the router comes up in setup mode. You again make changes, save them, and reboot. Again,the router comes up in setup mode. What is the most likely cause of this?（）
第6题：
You use two user accounts for your computer: standard user and administrator. You log on to your computer as standard user but are unable to make advanced configuration changes. You need to make advanced configuration changes while you are logged on as a standard user.What should you do?（）
A.A
B.B
C.C
D.D
第7题：
You need make configuration changes to an existing layer 3 switch in the Company network. On a multilayer Catalyst switch， which interface command is used to convert a Layer 3 interface to a Layer 2 interface？（）
第8题：
A. set
B. copy candidate active
C. apply-config
D. commit
第9题：
Which CLI mode allows you to make configuration changes?（）
第10题：
You have a single network segment. All servers run Windows Server 2003 Service Pack 2 (SP2). You have a DHCP server named Server1. Client computers receive IP addresses from Server1. You add a second network segment separated by a RFC 1542-compliant router. You need to ensure that computers in the new network segment can receive their IP configurations from Server1. You make the appropriate configuration changes on the router. What should you do on Server1?（）