show ip links
show cdp neighbor
show cdp neighbor detail
show ip clients
show ip route
None of the above
第1题:
A.application
B.hub
C.switch
D.bridge
E.router
第2题:
While troubleshooting a network connectivity issue, you suspect that a router may be missing a route, or may be receiving bad routing information to a destination. What command should you issue to view the route that the router will use to reach a given destination?()
A. ping
B. trace
C. show ip route
D. show interface
E. show cdp neighbors
第3题:
You are logged into a router and wish to view the layer 3 information about your neighboring Cisco routers. What IOS command gives layer 3 information for of the directly connected router interfaces?
A. show ip links
B. show cdp neighbor
C. show cdp neighbor detail
D. show ip clients
E. show ip route
F. None of the above
第4题:
You issue the ping interface tl-1/1/0 1.1.1.1 bypass-routing count 1000 rapid command.Which statement is correct?()
第5题:
A. Show ip protocols
B. Show ip route rip
C. Debug ip rip
D. Debug ip updates
E. Debug ip transactions
第6题:
You are troubleshooting a WAN connection for TestKing, and on the router you execute the, "debug ppp authentication" command, and view the following output:What kind of handshake was used for the PPP authentication?()
A. one-way
B. two-way
C. three-way
D. No handshakes required during authentication
E. None of the above
第7题:
While troubleshooting connectivity issues, you log into a remote router. From there,you wish to see the layer 1 and layer 2 status of the interface.Which of the following IOS commands would you issue to check the current IP addressing, as well as theyer 1 and layer 2 status of an interface?()
A. TK1# show version
B. TK1# show protocols
C. TK1# show interfaces
D. TK1# show controllers
E. TK1# show ip interface
F. TK1# show startup-config
第8题:
A. Network Interface Card
B. Hub
C. Bridge
D. Router
第9题:
A. enable cdp
B. cdp enable
C. cdp run
D. run cdp
第10题:
Which command would you configure globally on a Cisco router that would allow you to view directly connected Cisco devices?()