违法和不良信息举报 联系客服
免费注册 登录

An SVI has been configured on a device.  Which two statement

题目
多选题
An SVI has been configured on a device.  Which two statements are true about a switched virtual interface （SVI）？（）
A

An SVI is normally created for the default VLAN （VLAN1） to permit remote switch administration.

B

Multiple SVIs can be associated with a VLAN.

C

SVI is another name for a routed port.

D

An SVI is created by entering the no switchport command in interface configuration mode.

E

An SVI provides a default gateway for a VLAN.

参考答案和解析
正确答案： B,D
解析： 暂无解析
如果没有搜索结果或未解决您的问题，请直接 联系老师 获取答案。
相似问题和答案

第1题：

Refer to the exhibit. OSPF has been configured on all routers in the network and Area 1 has been configured as a NSSA. Which statement is true about the NSSA Area 1?()

A. Only redistributed RIP routes will appear in Area 1. They will be advertised via t ype 7 LSAs

B. No redistributed routes can appear in Area 1, only summary routes

C. Redistributed RIP and IGRP routes will appear in Area 1. They will be advertised via type 5 LSAs

D. Only redistributed IGRP routes will appear in Area 1. They will be advertised via type 7 LSAs


参考答案：D

第2题：

Which statement about Belgium is NOT true?

A.it is twice as big as Beijing.
B.it has two major ethnic groups.
C.it has gone through quite a few threats of division.
D.it has no government.

答案：D
解析：

第3题：

Click the Exhibit button.Assume the default-policy has not been configured.Given the configuration shown in the exhibit, which two statements about traffic from host_a in the HR zone to host_b in the trust zone are true? （）(Choose two.)

A. DNS traffic is denied.

B. HTTP traffic is denied.

C. FTP traffic is permitted.

D. SMTP traffic is permitted.


参考答案：A, C

第4题：

An SVI has been configured on a device.  Which two statements are true about a switched virtual interface （SVI）？（）

  • A、An SVI is normally created for the default VLAN （VLAN1） to permit remote switch administration.
  • B、Multiple SVIs can be associated with a VLAN.
  • C、SVI is another name for a routed port.
  • D、An SVI is created by entering the no switchport command in interface configuration mode. 
  • E、An SVI provides a default gateway for a VLAN.

正确答案:A,E

第5题：

A switch has been configured with two vlans and is connected to a router with a trunk for inter-vlan routing.OSPF has been configured on the router，as the routing protocol for the network.Which statement about thisnetwork is true？（）

  • A、For the two vlans to communicate，a network statement for the trunk interface needs to be added to the  OSPF configuration.
  • B、For the two vlans to communicate， a network statement for each subinterface needs to be  added  to the OSPF configuration.
  • C、Direct inter-vlan communication does not require OSPF
  • D、OSPF cannot be used if router-on-a-stick is configured on the router

正确答案:C

第6题：

A company has a small network,consisting of a single switch and a single router.The switch has been configured with two vlans,and route-on-a-stick is being configured on the router for inter-vlan routing.A trunk is configured to connect the switch to the router.What is the minimum number of router subinterfaces that are required for all the vlans to communicate?（）

A. one

B. three

C. two

D. zero


参考答案：C

第7题：

An SVI has been configured on a device. Which two statements are true about a switched virtualinterface （SVI）？（）

  • A、An SVI is normally created for the default VLAN （VLAN1） to permit remote switchadministration
  • B、Multiple SVIs can be associated with a VLAN
  • C、SVI is another name for a routed port
  • D、An SVI is created by entering the no switchport command in interface configuration mode
  • E、An SVI provides a default gateway for a VLAN

正确答案:A,E

第8题：

Refer to the exhibit. Looking at the topology diagram and the partial router configurations shown, which statement is true? ()

A.The NProuter has two OSPF neighbors in the "Full" adjacency state

B.The NProuter serial0/0 interface has the OSPF dead timer set to 10 seconds

C.The NProuter serial0/0 interface has been configured with an OSPF network type of "pointtopoint"

D.The 10.1.1.1 and 10.1.1.2 routers are not using the default OSPF dead and hello timers setting

E.The "Mismatched" error is caus ed by the expiration of the OSPF timers


参考答案：E

第9题：

Router R1 and R2 are both configured for HSRP.  Which two statements about the HSRP priorities  of these two routers are true？（）

  • A、 To assign the HSRP router priority in a standby group， the standby group-number priority  priority-value global configuration command must be used.
  • B、 The default priority of a router is zero （0）.
  • C、 The no standby priority command assigns a priority of 100 to the router.
  • D、 Assuming that preempting has also been configured， the router with the lowest priority in an  HSRP group would become the active router.
  • E、 When two routers in an HSRP standby group are configured with identical priorities， the router  with the highest configured IP address will become the active router.

正确答案:C,E

第10题：

Which statement best describes what is depicted in the show command output？（）

  • A、 IGMP snooping is not active for VLAN 120 because the IGMP feature has not been enabled on the switch with the feature igmp command.
  • B、 The IGMP snooping querier for VLAN 120 is not in a running state because the Loopback interface configured with 1.1.1.1/32 is currently in a down state.
  • C、 IGMP snooping has been disabled on the VLAN 120 SVI.
  • D、 IGMP snooping has been disabled for VLAN 120 in VLAN configuration mode.
  • E、 IGMP snooping is not active for VLAN 120 because VLAN 120 does not exist in the VLAN database.

正确答案:D

更多相关问题
相关内容