a separate motor
a cam
a generator
a chain
第1题:
第一组
Older loop scavenged engines may have a single injector mounted centrally in the cylinder head. Because the exhaust valve is in the center of the cylinder head on modern uniflow scavenged engines the fuel valves (2 or 3) are arranged around the periphery of the head. The pressure at which the injector operates can be adjusted by adjusting the loading on the spring. The pressures at which the injectors operate vary depending on the engine, but can be as high as 540 bar. Some injectors have internal cooling passages in them extending into the nozzle through which cooling water is circulated. This is to prevent overheating and burning of the nozzle tip. Injectors on modern engines do not have internal cooling passages. They are cooled by a combination of the intensive bore cooling in the cylinder head being close to the valve pockets and by the fuel which is re-circulated through the injector when the follower is on the base of the cam or when the engine is stopped. As well as cooling the injector, re-circulating the fuel when the engine is stopped keeps the fuel at the correct viscosity for injection by preventing it from cooling down. Fuel injectors must be kept in good condition to maintain optimum efficiency, and to prevent conditions arising which could lead to damage within the cylinder. Injectors should be changed in line with manufacturers&39; recommendations, overhauled and tested. Springs can weaken with repeated operation leading to the injector opening at a lower pressure than designed. The needle valve and seat can wear which together with worn nozzle holes will lead to incorrect atomization and dribbling.
Modern uniflow scavenged engines have______.
A.a single injector mounted in the center of the cylinder head
B.several injectors mounted around the external boundary of the cylinder head
C.a single injector mounted at the external boundary of the cylinder head
D.several injectors mounted in the center of the cylinder head
第2题:
The amount of fuel delivered by a helical plunger fuel injection pump is controlled by ______.
A.varying the pump discharge pressure
B.varying the pump return pressure
C.rotation of the pump plunger
D.rotation of the pump barrel
第3题:
If you suspect a diesel engine is misfiring due to air leakage into the fuel system, you should begin looking for the leak at the
A.fuel line connections to the cylinder injection valves
B.gasket surfaces of the fuel oil filters
C.discharge fittings of the fuel injector pumps
D.suction side of the fuel oil transfer pump
第4题:
crankshaft
camshaft
piston rod
rack and pinion
第5题:
the needle valve
the plunger
the piston
the cylinder
第6题:
An increase in the fuel injection pump discharge pressure can be caused by a/an _______.
A.leaking delivery valve
B.excessive bearing end play
C.plugged injector spray hole
D.increased plunger stroke
第7题:
Fuel injector的中文意思是()。
第8题:
Which of the following problems is the main source of fuel pump and injection system malfunctions?
A.Improper lubrication
B.Air in the fuel system
C.Coated fuel lines
D.Excessive vibration
第9题:
top and bottom
to and fro
up and down
back and forth
第10题:
regulating the speed of the turbocharger
rotating the fuel injector pump plunger
regulating the speed of the fuel oil transfer pump
changing engine timing