Grinding to eliminate shallow surface defects should be done

The majority of product defects could be prevented in most processes if manufactures would do the following:

A . Increase the use of acceptance control charts instead of standard three-sigma control charts.

B . Make a concerted effort to eliminate the potential for product defects in the design stage.

C . Create a quality control department.

D . A and B.

E . A and C

158 The Pareto Principle is a technique used by quality managers to determine which quality control problems of a particular service or manufacturing process should be corrected. Which of the following statements represents the philosophy of the principle?

A. In order to minimize financial losses from quality control problems, all problems which have a measurable cost associated with them should be corrected.

B. the majority of defects are caused by a small percentage of the identifiable problems. Improvements efforts should be reserved for these vital few problems.

C. in order to achieve zero defects, all quality control problems, including those which do not have a direct financial cost should be corrected.

D. generally, 80 % of the quality control problems are justifiable for correction via cost-benefit analysis. The remaining 20% are not financially worthy of improvement efforts.

E. A and D

The zero defects concept

A . is a performance standard for management

B . is a motivational technique that promotes "doing it right the first time".

C . is used by management to communicate to all employees that everyone should do things right the first time.

D . A and C.

E . B and C

The bridge should inform the engine room______before passing through congested or shallow waterway.

A.24 hours

B.2 hours

C.1 hour

D.15 minutes

On discovery of new dangers, of changes or defects in aids to navigation, Masters of vessels should immediately inform ______.

A.their government

B.their port of registry

C.British Government

D.Hydrographer of the Navy of Ministry of Defense of U.K

48 The majority of product defects could be prevented in most processes if manufactures would do the following:

A. Increase the use of acceptance control charts instead of standard three-sigma control charts.

B. Make a concerted effort to eliminate the potential for product defects in the design stage.

C. Create a quality control department.

D. A and B.

E. A and C

A、the blinds

B、the blind

C、blinds

D、blind

The Pareto Principle is a technique used by quality managers to determine which quality control problems of a particular service or manufacturing process should be corrected. Which of the following statements represents the philosophy of the principle?

A . In order to minimize financial losses from quality control problems, all problems which have a measurable cost associated with them should be corrected.

B . the majority of defects are caused by a small percentage of the identifiable problems. Improvements efforts should be reserved for these vital few problems.

C . in order to achieve zero defects, all quality control problems, including those which do not have a direct financial cost should be corrected.

D . generally, 80 % of the quality control problems are justifiable for correction via cost-benefit analysis. The remaining 20% are not financially worthy of improvement efforts.

E . A and D

Before adjusting the derrick, what work should be done?

The writer suggests that pruning should be done in winter because______.

A. the cut surface can heal more quickly

B. open wounds on the tree run the less risk of getting diseased

C. a gardener can do pruning more easily

D. the leaves can interfere