raw water pump discharge
expansion tank outlet
cooling water heat exchanger
outlet engine jacket water outlet
第1题:
Which of the following factors tends to increase scale formation on the saltwater side of a heat exchanger used in a diesel engine cooling water system?
A.Baffle plates that have been bent during prior removal
B.Leaks m the cooler tube nest
C.Operating the engine while maintaining a high sea water outlet temperature
D.A punctured sea water strainer supplying cooling water to the heat exchanger
第2题:
supplying high pressure oil into a hydraulic motor
supplying high temperature air into the cylinder
supplying high pressure air into the cylinder
electrical igniting
第3题:
High firing pressures and low exhaust temperature in a diesel engine may resultfrom( ).
A.decreased piston to cylinder head clearance
B.increased exhaust system back pressure
C.early fuel injection timing
D.low scavenge air temperature
第4题:
Baffle plates that have been bent during prior removal
Leaks in the cooler tube nest
Operating the engine while maintaining a high sea water outlet temperature
A punctured sea water strainer supplying cooling water to the heat exchanger
第5题:
notify the duty officer, reduce the engine speed, take some measures to remove failures
notify the duty officer and stop the engine immediately, find the cause and remove failures
notify the C/E
notify the captain
第6题:
High diesel engine cooling water temperatures can be caused by ______.
A.air in the cooling system
B.an overhauled water pump
C.correct amount of coolant
D.no air in the cooling system
第7题:
stop the engine immediately to prevent damage
increase lube oil pressure
slow the engine allowing it to gradually cool
decrease the cooling water it temperature to the water jacket
第8题:
A two stroke diesel engine exhaust temperature will be lower than a four stroke diesel engine of the same displacement because the _____. ① MEP is lower and the scavenging air is cooling the exhaust gases ② valve overlap in a four stroke
A.①
B.②
C.① and ②
D.Neither ① nor ② is correct
第9题:
a broken shaft on the freshwater pump
an excessive accumulation of scale exchanger
an incorrect thermostatic element operating range
lube oil in the cooling water
第10题:
runs out of fuel
has low lubricating oil pressure
exceeds a set maximum speed
has high cooling water temperature