违法和不良信息举报 联系客服
免费注册 登录

Refer to the exhibit. Which two statements are correct？ （Cho

题目
多选题
Refer to the exhibit. Which two statements are correct？ （Choose two.）（）
A

All six routes will be installed in the routing table.

B

Two routes will be installed in the routing table.

C

Four routes will be installed in the routing table.

D

All the routes were redistributed into BGP from an IGP.

E

All the routes were originated by BGP with the network command.

如果没有搜索结果或未解决您的问题，请直接 联系老师 获取答案。
相似问题和答案

第1题：

Which two statements regarding JUNOS architecture are correct?()

A.The Routing Engine handles all exception traffic.

B.The Routing Engine synchronizes the route table with the PFE

C.The Routing Engine is hot-pluggable.

D.The Routing Engine controls the PFE


参考答案：C, D

第2题：

Refer to the exhibit. On the basis of the partial configuration, which two statements are correct? ()

A. Only routes 10.0.1.0/24 will be sent out all interfaces.

B. Only routes matching 10.0.0.0/8 will be advertised out interfaces other than Ethernet 0.

C. Only routes matching 10.0.0.0/8 will be advertised out Ethernet 0.

D. Only routes matching 10.0.1.0/24 will be advertised out Ethernet 0.

E. Only routes 10.0.1.0/24 will be allowed in the routing table.

F. All rout es will be advertised out interfaces other than Ethernet 0.


参考答案：B, D

第3题：

Which of the following statements about ORACLE is (are) correct?

Ⅰ.ORACLE follows SQL standard

Ⅱ.ORACLE database defines two logical types: table and view

A．Ⅰonly

B．Ⅱ only

C．Ⅰ and Ⅱ

D．none of the above


正确答案：C

第4题：

Refer to the exhibit. Based upon the configuration, you need to understand why the policy routi match counts are not increasing. Which would be the first logical step to take?()

A. Confirm if there are other problematic route - map statements that precede divert.

B. Check the access list for log hits.

C. Check the routing table for 212.50.185.126.

D. Remove any two of the set clauses. (Multiple set clause entries will cause PBR to use the routing table.)


参考答案：B

第5题：

Refer to the exhibit. Two routers are connected by Frame Relay and are running OSPF bet ween them. Each router has been configured with the appropriate network statements under router ospf 1, but the routers are not forming an adjacency. Which of the following three commands could be configured on each router to correct this problem?（）

A. RouterC(config - if)#ip ospf network broadcast RouterD(config - if)#ip ospf network broadcast

B. RouterC(config - if)#ip ospf network point - to - point RouterD(config - if)#ip ospf network point - to - point

C. RouterC(config - router)#neighbor 10.100. 100.4 RouterD(config - router)#neighbor 10.100.100.3

D. RouterC(config - router)#neighbor 10.255.255.254 RouterD(config - router)#neighbor 10.255.255.253


参考答案：A, B, D

第6题：

Refer to the exhibit. Which of the following statements is true? ()

A. BGP NSF awareness is enabled

B. SSO for BGP NSF capability is enabled

C. BGP graceful restart awareness is enabled

D. 10.11.1.187 is configured as an NSF-capable BGP neighbor


参考答案：A

第7题：

Refer to the exhibit. Which two Cisco IOS commands on R2 would verify its OSPF neighbor relationships?()

A.show ip ospf

B.show ip ospf interface

C.show ip ospf neighbor

D.show ip ospf database

E.show ip ospf statistics

F.show running - config begin router ospf


参考答案：B, C

第8题：

Which three statements are correct about Rate Limiters? ()(Choose three.)

A. one-rate rate limiters

B. two-rate rate limiters

C. two-rate rate limiters is the default

D. one-rate rate limiters is the default

E. there is no default it must be configured


参考答案：A, B, C

第9题：

Refer to the exhibit. A new TAC engineer came to you for advice. A GRE over IPsec tunnel was configured, but the tunnel is not coming up. W hat did the TAC engineer configure incorrectly?()

A. The crypto isakmp configuration is not correct.

B. The crypto map configuration is not correct.

C. The interface tunnel configuration is not correct.

D. The network configuration is not correct; netw ork 172.16.1.0 is missing.


参考答案：A

第10题：

Refer to the exhibit. You want to use all the routes in the EIGRP topology for IP load balancing. Which two EIGRP subcommands wou ld you use to accomplish this goal?()

A. traffic - share balanced

B. distance

C. maximum- paths

D. default - network

E. variance


参考答案：C, E

更多相关问题
相关内容