set snmp trap-group my-trap-group targets 172.16.17.1
set snmp targets 172.16.17.1
set snmp trap-group my-trap-group link-status
set snmp trap-group my-trap-group categories link
第1题:
You, like many of your classmates, probably have been in such a situation where you are asked to do something to help a foreign friend. (翻译)
第2题:
You have been asked to configure a login class which will permit its users to view and edit the configuration. The class should only allow the configuration of the interfaces and firewall heirarchies. Which configuration correctly accomplishes this?()
A.A
B.B
C.C
D.D
第3题:
A.Do you try
B.Have you tried
C.Are you trying
D.Have you been trying
第4题:
You are the network administrator of a small Layer 2 network with 50 users. Lately, users have been complaining that the network is very slow. While troubleshooting, you notice that the CAM table of your switch is full, although it supports up to 12,000 MAC addresses. How can you solve this issue and prevent it from happening in the future?()
第5题:
You‘re working at TestKing as a network administrator when your MCSE assistant calls you for help. He has attempted to configure Router TK1 and incorrectly configured the router interface with a subnet broadcast address. You have to correct this by first removing the incorrect IP address and then re-entering the first usable IP address of the same subnet.How will you do this?()
A.
B.
C.
D.
E.
第6题:
A. resolve
B. indirect
C. next-hop
D. recursive
第7题:
A. After the router ospf 10 and passive - interface s0/0 commands have been issued , the s0/0 interface will not send any OSPF updates, but will receive routing updates on that interface
B. When you use the passive - interface command with RIPv2, multicasts are sent out the specified interface
C. After the router rip and passive -interface s0/0 commands have been issued, the s0/0 interface will not send any RIP updates, but will receive routing updates on that interface
D. When you use the passive - interface command with EIGRP, hel lo messages are not sent out the specified interface
E. After the router eigrp 10 and passive - interface s0/0 commands have been issued, the s0/0 interface will not send any EIGRP updates, but will receive routing updates on that interface
F. When you use the passive - interface command with OSPF, hello messages are not sent out the specified interface
第8题:
This is a piece of very important news. You must have it ____ to your country at once.
A、sent of
B、sent off
C、send of
D、send off
第9题:
第10题:
You have been asked to configure your MX240 with a default route toward your upstream ISP atIP address 192.168.100.1. Which command successfully completes this task?()