show services unified-access-control authentication-table
show auth table
show services unified-access-control policies
show services unified-access-control captive-portal
第1题：
You have a firewall enforcer protecting sensitive internal resources in a data center. The network traversed by endpoint traffic is semi-trusted, so you need to encrypt the traffic between the endpoints accessing the resources and the firewall enforcer.Which type of policies provide this level of protection?（）
A. resource access policies
B. Host Enforcer policies
C. source IP enforcement policies
D. IPsec enforcement policies
第2题：
A user is successfully authenticating to the network but is unable to access protected resources behind a ScreenOS enforcer. You log in to the ScreenOS enforcer and issue the command get auth table infranet and you do not see the user listed.Which two event log settings on the Junos Pulse Access Control Service must you enable to troubleshootthis issue?（）
A. Connection Requests
B. System Errors
C. Enforcer Events
D. Enforcer Command Trace
第3题：
You notice that during peak hours, some firewall enforcers contain a high number of auth table entries. As you investigate the issue, you discover that all users are getting auth table mappings to all firewalls, which is not acceptable.What should you do on the Junos Pulse Access Control Service to resolve this problem?（）
A. Delete the default auth table mapping policy
B. Create auth table mapping policies that route users to specific resources
C. Create Resource Access policies that permit access to specific resources
D. Create Source Interface policies that route users to specific resources
第4题：
You notice that during peak hours, some firewall enforcers contain a high number of auth table entries. As you investigate the issue, you discover that all users are getting auth table mappings to all firewalls, which is not acceptable. What should you do on the Junos Pulse Access Control Service to resolve this problem?（）
第5题：
If you want to reset your configuration back to the factory defaults but keep your logs and reports，Which CLI command should you use？（）
第6题：
You are receiving reports of possible unauthorized access to resources protected by a firewall enforcer running the Junos OS. You want to verity which users are currently accessing resources through the enforcer.Which command should you use to verify user access on the enforcer?（）
A. show services unified-access-control authentication-table
B. show auth table
C. show services unified-access-control policies
D. show services unified-access-control captive-portal
第7题：
You have a firewall enforcer protecting resources in a data center. A user is experiencing difficulty connecting to a protected resource.Which two elements must exist so the user can access the resource?（）
A. Resource access policy on the MAG Series device
B. IPsec routing policy on the MAG Series device
C. General traffic policy blocking access through the firewall enforcer
D. Auth table entry on the firewall enforcer
第8题：
You have a firewall enforcer receiving resource access policies from a Junos Pulse Access Control Service. You are using Network and Security Manager (NSM) for configuration management on that firewall. The firewall can also be configured using its built-in command-line interface (CLI) or Web-based user interface (WebUI).To avoid conflicting configurations, which two interfaces must you use to configure the firewall enforcer?（）
A. CLI
B. WebUI
C. NSM
D. Junos Pulse Access Control Service
第9题：
You are configuring an SRX210 as a firewall enforcer that will tunnel IPsec traffic from several Junos Pulse users.Which two parameters must you configure on the SRX210?（）
第10题：
You are receiving reports of possible unauthorized access to resources protected by a firewall enforcer running the Junos OS. You want to verity which users are currently accessing resources through the enforcer.Which command should you use to verify user access on the enforcer?（）