单选题What is the first step in BGP route selection?()A The local router prefers the route with the shortest as-path.B The router first verifies that it has a route to thebgp Next Hop IP address.C The local router prefers the route from the peer with the low

题目
单选题
What is the first step in BGP route selection?()
A

The local router prefers the route with the shortest as-path.

B

The router first verifies that it has a route to the bgp Next Hop IP address.

C

The local router prefers the route from the peer with the lowest peer id address.

D

The local router prefers the route learned from an ebgp peer over a route learned from an ibgp peer.

如果没有搜索结果或未解决您的问题,请直接 联系老师 获取答案。
相似问题和答案

第1题:

The fol lowing line of output was extracted from the output of the show ip bgp command on Router R1. Which of the following can be determined from this output?()Network Next Hop Metric LocPrf Weight Path* 130.1.1.0/28 1.1.1.1 0 1 2 3 4 i

A. The route is learne d from an eBGP peer

B. The route has no more than three ASNs in the AS_PatH

C. The route is the best route for this prefix

D. None of these facts can be positively determined by this output


参考答案:A

第2题:

A router has two paths to reach another network in a different autonomous system. Neither route was generated by the local router and both routes have the same default weight an d local preference values.Which statement is true about how BGP would select the best path?()

A. To influence one route to be preferred, its default local preference value will be changed via the use of the command bgp default local - preference 50

B. Th e router will prefer the shortest autonomous system path

C. If the command bgp always - compare - med has been given, then the router will prefer the route with the highest MED

D. The router will prefer the route with the lower MED


参考答案:B

第3题:

You have been asked to establish reachability between Router 1‘s and Router 2‘s loopback addresses as shown in the exhibit. Which two steps will accomplish this task?()

A. Create a static route on Router 1 to 172.17.28.1 with a next hop of 10.10.10.2.

B. Create a static route on Router 1 to 172.17.28.1 with a next hop of 10.10.10.1.

C. Create a static route on Router 2 to 172.17.25.1 with a next hop of 10.10.10.1.

D. Create a static route on Router 1 to 172.17.25.1 with a next hop of 10.10.10.2.


参考答案:A, C

第4题:

In BGP routing,what does the rule of synchronization mean?()

  • A、A BGP router can only advertise an EBGP learned route,provided that the route is an IGP route in the routing table.
  • B、A BGP router can only advertise an IBGP learned route,provided that the route is an IGP route in the routing table.
  • C、A BGP router can only advertise an IBGP learned route,provided that the route is an IGP route that is not in the routing table.
  • D、A BGP router can only advertise an EBGP learned route,provided that the route is a metric of 0 in the BGP table.

正确答案:B

第5题:

What is the most likely reason that an IBGP route that has been selected as a best route is not entered into the IP routing table?()

  • A、Route reflectors are not passing updates properly.
  • B、BGP synchronization has been enabled.
  • C、The next-hop address is unreachable.
  • D、No loopback interface has been configured on a router.

正确答案:B

第6题:

Which BGP command provides the router ID, local preference, next hop, and BGP path in its output?()

A. show ip route bgp

B. show ip bgp

C. show ip bgp neighbors

D. show ip bgp summary


参考答案:B

第7题:

A router receives information about network 192.168.10.0/24 from multiple sources. What will the router consider the most reliable information about the path to that network()。

A.a directly connected interface with an address of 192.168.10.254/24

B.a static route to network 192.168.10.0/24

C.a RIP update for network 192.168.10.0/24

D.an OSPF update for network 192.168.0.0/16

E.a default route with a next hop address of 192.168.10.1

F.a static route to network 192.168.10.0/24 with a local serial interface configured as the next hop


参考答案:A

第8题:

The following line of output was gathered on Enterprise Router Ent1 using the command show ip route. Which of the following answers is most likely to be true, based on thi s output?()B 128.107.0.0 [20/10] via 11.11.11.11, 00:02:18

A. This router has set the Weight of this route to 10.

B. This router‘s BGP table lists this route as an iBGP route.

C. This router‘s MED has been set to 10.

D. This router‘s BGP table lists an AS_Path length of 10 for this route.


参考答案:C

第9题:

Which BGP command provides the router ID, local preference, next hop, and BGP path in its output?()

  • A、show ip route bgp
  • B、show ip bgp
  • C、show ip bgp neighbors
  • D、show ip bgp summary

正确答案:B

第10题:

You have a router running BGP for the MPLS network and OSPF for the local LAN network at the sales office. A route is being learned from the MPLS network that also exists on the OSPF local network. It is important that the router chooses the local LAN route being learned from the downstream switch running OSPF rather than the upstream BGP neighbor. Also, if the local OSPF route goes away, the BGP route needs to be used. What should be configured to make sure that the router will choose the LAN network as the preferred path?()

  • A、static route needs to be added
  • B、floating static route needs to be added
  • C、bgp backdoor command
  • D、ospf backdoor command

正确答案:C

更多相关问题