Refer to the exhibit. The two exhibit devices are the only Cisco devices on the network. The serial network between the two devices has a mask of 255.255.255.252. Given the output that is shown, what three statements are true of these devices? （）
A.The Manchester serial address is 10.1.1.1
B.The Manchester serial address is 10.1.1.2
C.这个Manchester路由器串口地址为：10.1.12
D.The London router is a Cisco 2610.
E.The Manchester router is a Cisco 2610.
F.The CDP information was received on port Serial0/0 of the Manchester router.
G.The CDP information was sent by port Serial0/0 of the London Router.
第1题：
Refer to the exhibit. You have a non-Cisco switch that is not communicating properly while connected to the distribution-layer Cisco switching fabric.Which two best-practice actions can you take to overcome this problem? （）(Choose two.)
A. Turn off MST (802.1s) on all switches.
B. Turn on MST (802.1s) on all switches.
C. Turn on RSTP (802.1w) on all switches.
D. Turn off RSTP (802.1w) on all switches.
第2题：
A.show ip ospf
B.show ip ospf interface
C.show ip ospf neighbor
D.show ip ospf database
E.show ip ospf statistics
F.show running - config begin router ospf
第3题：
A. Define the virtual router IP address on both WXC devices.
B. Add a static route for the virtual router IP address on both WXC devices.
C. Define the physical IP address of each router on each respective WXC device.
D. Leave the default gateway field in the WXC device blank; it will automatically detect the active gateway address.
第4题：
Cisco IDS sensors form the eyes and ears of your Cisco network intrusion detection system.Placing sensors correctly throughout your network is crucial to successfully implementing your Cisco intrusion detection system . Where can an IPS sensor be placed in an enterprise network?（）
A. core layer
B. bridging two VLANs on one switch
C. between two Layer 2 devices withtrunking
D. between two Layer 2 devices withouttrunking
第5题：
A. Only traffic with a destination from 10.10.0.0/19 will be permitted.
B. Router RAR1 will accept only route 10.10.0.0/19 from its BGP neighbor.
C. Only traffic going to 10.10.0.0/19 will be permitted.
D. Router RAR1 will send only route 10.10.0.0/19 to its BGP neighbor.
第6题：
A. Only routes 10.0.1.0/24 will be sent out all interfaces.
B. Only routes matching 10.0.0.0/8 will be advertised out interfaces other than Ethernet 0.
C. Only routes matching 10.0.0.0/8 will be advertised out Ethernet 0.
D. Only routes matching 10.0.1.0/24 will be advertised out Ethernet 0.
E. Only routes 10.0.1.0/24 will be allowed in the routing table.
F. All rout es will be advertised out interfaces other than Ethernet 0.
第7题：
A. stub
B. totally stubby
C. NSSA
D. totally NSSA
第8题：
Refer to the exhibit. You want to minimize the downtime that results from supervisor engine switchovers on Cisco 6500 Series Switches and Cisco 7600 Series Routers. To achieve this, you are considering deploying a Cisco Nonstop Forwarding with Stateful Switchover solution using OSPF.In the exhibit you can see the output of the show ip ospf neighbor detail command.Which trait of systems using Cisco Nonstop Forwarding with Stateful Switchover and OSPF is shown in the exhibit output and will impact your plan?（）
A. Stateful Switchover for Cisco Nonstop Forwarding only works with BGP.
B. Stateful Switchover for Cisco Nonstop Forwarding must be configured on all adjacent routers.
C. Cisco Nonstop Forwarding with Stateful Switchover helper mode is not supported on the adjacent router.
D. Cisco Nonstop Forwarding with Stateful Switchover helper mode for OSPF has been promiscuousstandardized and is supported on the adjacent router.
第9题：
A. The peer group shortens the EBGP configuration
B. The peer group shortens the IBGP configuration
C. All the configured neighbors are in autonomous system 100
D. Three AS - path filters are applied to each BGP neighbor
E. Only the outgoing filters are applied to BGP updates
第10题：
Refer to the exhibit. When running EIGRP, What is required for RouterA to exchange routing updates with RouterC?（）