Refer to the exhibit. EIGRP is configured with the default configuration on all routers. A

Refer to the exhibit. OSPF has been configured on all routers in the network. However, router R1 does not receive a default route to router R2 as in tended. Which configuration change would ensure that R1 would receive a default route from R2? （）

A. Add the area 1 stub command on routers R1.

B. Add the always keyword to the default - information originate configuration command on router R2.

C. Remov e the default information originate configuration command from router R2 and place it on router R1.

D. Add the ip route 5.0.0.0 255.255.255.0 0.0.0.0 command to router R2.

Refer to the exhibit. EIGRP has been configured on router D. Router C is performing mutual redistribution between EI GRP and OSPF. While verifying that the redistribution is functioning properly, you discover that while router C has all of the EIGRP routes in its routing table, router A does not have any routes from the EIGRP domain. What on router C may be the cause o f the problem?（）

A. The no auto - summary command needs to be added under router eigrp 1

B. The subnets keyword was not included in the redistribute command under router ospf 1

C. The metric specified for the redistributed EIGRP routes is too large; m aking the EIGRP routes unreachable by router A

D. The default - information originate command needs to be added under router ospf 1

E. The administrative distance of either OSPF or EIGRP must be changed so that EIGRP has a higher administrative distanc e than OSPF

Refer to the exhibit. The routing protocols EIGRP and OSPF have been configured as indicated in the exhibit. Given the partial configuration of router R2, which network will be present in th e routing table of R4?（）

A. Network B

B. Network A and Network B

C. Network A

D. neither Network A nor Network B

Refer to the exhibit. A partial routing configuration is shown. Complete the configuration so that only the default - network is redistributed from EIGRP 190 into EIGRP 212. Which ACL statement completes the configuration correctly? （）

A. access - list 100 permit ip 0.0.0.0 0.0.0.0 0.0.0.0 0.0.0 .0

B. access - list 100 permit ip host 0.0.0.0 any

C. access - list 100 permit ip any host 0.0.0.0

D. A default -network cannot be redistributed between routing processes.

A. The crypto isakmp configuration is not correct.

B. The crypto map configuration is not correct.

C. The interface tunnel configuration is not correct.

D. The network configuration is not correct; netw ork 172.16.1.0 is missing.

Refer to the exhibit and the partial configuration on router R2. On router R4 all RIP routes are redistributed into the OSPF domain. A second redistribu tion is configured on router R2 using a route map. Based on the configuration on router R2, which EIGRP external routes will be present in the routing table of R1?（）

A. the routes originating from the RIP routing domain

B. the routes originating from the OSPF stub area

C. all OSPF inter and intra - area routes

D. all routes originating from RIP and OSPF routing domains

A.No dynamic interior routing protocol can summarize as shown

B.Unless configured otherwise, EIGRP would automatically summa rize the prefixes as shown in the exhibit

C.With this IP addressing scheme, EIGRP can be manually configured to summarize prefixes at the specified summarization points

D.The IP address design lends itself to OSPF Each summarizing router would be an ABR, summarizing to the next area in the address hierarchy

A. Any routes learned by R2 from the interface tied to the 172.16.0.0 network will not be advertised to neighbors on the 192.168.2.0 network.

B. Only routes learned by R2 from the interface tied to the 172.16.0.0 network will be advertised to neighbors on the 192.168.2.0 network.

C. Only the 172.16.0.0 network will be advertised to neighbors on the 192.168.2.0 network.

D. All networks, except the 172.16.0.0 network will be advertised to neighbors on the 192.168.2.0 network .

A. router rip

B. router eigrp 10

C. redistribute eigrp 10

D. redistribute rip

E. default - metric 10000 100 255 1 1500

F. default - metric 5

Refer to the exhibit. R1 accesses the Internet using E0/0. You have been asked to co nfigure R1 so that a default route is generated to its downstream devices (191.0.0.1 and 192.0.0.1). Which commands would create this configuration? （）

A.router eigrp 190redistribute static ! ip route 0.0.0.0 0.0.0.0 Null0

B.ip default - network 2 0.0.0.0

C.router eigrp 190 redistribute static ! ip route 0.0.0.0 255.255.255.255 Null0

D.ip default - network 20.20.20.0