While troubleshooting an issue in the Ezonexam LAN you notice that a network interface port has collision detection and carrier sensing enabled on a shared twisted pair network. From this statement, what is known about the network interface port?
A. This is an Ethernet port operating at half duplex
B. This is an Ethernet port operating at full duplex
C. This is a port on a network interface card in a PC
D. This is 10 MB/s switch port
E. This is a 100 MB/s switch port
F. None of the above
第1题：
As a network administrator, you issue the interface auto qos voip cisco-phone command on a port in an edge network. It is possible for a Cisco Catalyst switch to check if a Cisco IP Phone is directly attached to that port by:（）
A. using DHCP snooping
B. snooping the incoming 802.1Q VLAN tag
C. using CDP
D. snooping the CoS marking on the incoming frames
第2题：
A.This switch has more than one interface connected to the root network segment in VLAN 2.
B.This switch is running RSTP while the elected designated switch is running 802.1d Spanning Tree.
C.This switch interface has a higher path cost to the root bridge than another in the topology.
D.This switch has a lower bridge ID for VLAN 2 than the elected designated switch.
第3题：
Your network contains a server named Server1 that has the Routing role service installed. Server1 has two network connections. One network connection connects to the internal network. The other network connection connects to the Internet.All network connections connected to the internal network use private IP addresses. You install a Web server named Web1. Web1 hosts a secured Web site that only allows connections over TCP port 8281. Web1 is connected to the internal network.You need to ensure that the secure Web site can be accessed from the Internet.What should you do from the Routing and Remote Access console？（）
A. Configure Routing Information Protocol (RIP), and then activate authentication on the RIP interface.
B. Configure Routing Information Protocol (RIP), and then configure the incoming packet protocol settings on the RIP interface.
C. Configure Network Address Translation (NAT), and then add a new service to the NAT interface.
D. Configure Network Address Translation (NAT), and then enable the Secure Web Server (HTTPS) service on the NAT interface.
第4题：
You are the network administrator of a small Layer 2 network with 50 users. Lately， users have beencomplaining that the network is very slow. While troubleshooting， you notice that the CAM table of yourswitch is full， although it supports up to 12， 000 MAC addresses. How can you solve this issue and preventit from happening in the future？（）
第5题：
You are the network administrator of a small Layer 2 network with 50 users. Lately， users have been complaining that the network is very slow. While troubleshooting， you notice that the CAM table of your switch is full， although it supports up to 12，000 MAC addresses. How can you solve this issue and prevent it from happening in the future？（）
第6题：
Refer to the exhibit. A junior network administrator was given the task of configuring port security on SwitchA to allow only PC_A to access the switched network through port fa0/1. If any other device is detected, the port is to drop frames from this device. The administrator configured the interface and tested it with successful pings from PC_A to RouterA, and then observes the output from these two show commands.Which two of these changes are necessary for SwitchA to meet the requirements? （）
A.Port security needs to be globally enabled.
B.Port security needs to be enabled on the interface.
C.Port security needs to be configured to shut down the interface in the event of a violation.
D.Port security needs to be configured to allow only one learned MAC address.
E.Port security interface counters need to be cleared before using the show command.
F.The port security configuration needs to be saved to NVRAM before it can become active.
第7题：
A network interface port has collision detection and carrier sensing enabled on a shared twisted pair network. From this statement, what is known about the network interface port（）。
第8题：
Split horizon has been enabled within the Ezonexam routed network. Which one of the following statements best explains the split horizon rule?
A．Only routers can split boundaries (horizons) between networks in separate AS numbers.
B．Each AS must keep routing tables converged to prevent dead routes from being advertised across boundaries.
C．Once a route is received on an interface, advertise that route as unreachable back out the same interface.
D．Information about a route should never be sent back in the direction from which the original update came.
E．None of the above
第9题：
While troubleshooting a network outage, you discover that an employee brought a switch from home into the office to connect additional equipment to the network. In order to increase his speed, he connected this switch to both network ports in his office, resulting in a bridge loop. Which of these can you implement to prevent future occurrences of this issue?（）
第10题：
A network interface port has collision detection and carrier sensing enabled on a shared twisted pair network. From this statement, what is known about the network interface port?（）