违法和不良信息举报 联系客服
免费注册 登录

Which two routing interface para

题目

Which two routing interface parameters are supported in OSPF implementations?（）

  • A、retransmit - interval
  • B、de ad - interval
  • C、stub area
  • D、virtual link
  • E、NSSA area
如果没有搜索结果或未解决您的问题，请直接 联系老师 获取答案。
相似问题和答案

第1题：

Which two routing interface parameters are supported in OSPF implementations?()

A. retransmit - interval

B. de ad - interval

C. stub area

D. virtual link

E. NSSA area


参考答案：A, B

第2题：

Which routing protocol will continue to receive and process routing updates f rom neighbors after the passive - interface router configuration command is entered?（）

  • A、EIGRP
  • B、RIP
  • C、OSPF
  • D、IS - IS

正确答案:B

第3题：

Which two statements are true about hierarchical architecture? ()(Choose two.)

A. You can assign a logical interface to multiple zones.

B. You cannot assign a logical interface to multiple zones.

C. You can assign a logical interface to multiple routing instances.

D. You cannot assign a logical interface to multiple routing instances.


参考答案：B, D

第4题：

Which two statements are true about the role of split horizon？（）

  • A、It is a function used by routing protocols to install routes into routing table
  • B、It is a function that prevents the advertising of routes over an interface that the router is usingto reach a route
  • C、Its function is to help avoid routing loops.
  • D、It is a redistribution technique used by routing protocols

正确答案:B,C

第5题：

For which two functions is the Routing Engine responsible？（）

  • A、packet forwarding
  • B、queuing functions
  • C、routing protocol control
  • D、JUNOS software operation

正确答案:C,D

第6题：

Use the output from the router shown in the graphic above to determine which of the following are correct.()

A. Router John uses a link-state routing protocol.

B. Router John will receive routing updates on the Serial0/0 interface.

C. Router John will receive routing updates on the Serial0/1 interface.

D. Router John will send routing updates out the Serial0/0 interface.

E. Router John will send routing updates out the FastEthernet0/0 interface.

F. Router John will send routing updates out the Serial0/1 interface.


参考答案：B, D

第7题：

A switch has been configured with two vlans and is connected to a router with a trunk for inter-vlan routing.OSPF has been configured on the router，as the routing protocol for the network.Which statement about thisnetwork is true？（）

  • A、For the two vlans to communicate，a network statement for the trunk interface needs to be added to the  OSPF configuration.
  • B、For the two vlans to communicate， a network statement for each subinterface needs to be  added  to the OSPF configuration.
  • C、Direct inter-vlan communication does not require OSPF
  • D、OSPF cannot be used if router-on-a-stick is configured on the router

正确答案:C

第8题：

Which routing protocol will continue to receive and process routing updates f rom neighbors after the passive － interface router configuration command is entered?()

A. EIGRP

B. RIP

C. OSPF

D. IS - IS


参考答案：B

第9题：

YOU issue the pins interface tl-1/1/0 1.1.1.1 bypass-routing count 1000 rapid command.Which statement is correct?（）

  • A、The bypass-routing parameter is used to test the density on the TI line.
  • B、The bypass-routing parameter cannot be used on a T1 interface.
  • C、The bypass-routing parameter allows you to ping a host through an interface that has no route through it.
  • D、The bypass-routing parameter allows you to ping a local WAN interface without generating any outbound traffic

正确答案:C

第10题：

Which three causes could prevent a host from getting an IPv6 address with stateless autoconfiguration？（）

  • A、The autoconfig command is missing from the router interface.
  • B、IPv6 multicast routing is not enabled on the router interface.
  • C、IPv6 unicast routing is not enabled on the router interface.
  • D、The router interface is configured with a /63 mask.
  • E、The router interface is configured with a /65 mask.

正确答案:C,D,E

更多相关问题
相关内容