A router has EIGRP configured as the only routing protocol. How does EIGRP respond if there is no feasible successor route to a destination network and the successor route fails?（）
第1题：
Router R1 has a connected route for 10.1.1.0/24 off interface Fa0/0. Interface Fa0/0 has been enabled for OSPF due to a router ospf 1 and network 10.0.0.0 0.0.0.255 area 0 command. R1 also has EIGRP configured, with the redistribute ospf 1 metric 1000 100 10 1 1500 command configured under EIGRP.Which one of the following is true?（）
A. R1 will not redistribute 10.1.1.0/24 into EIGRP, because R1 knows it as a connected route and not as an OSPF route.
B. For any OS PF routes redistributed into EIGRP, the metric components includea value equivalent to 1 Mbps of bandwidth.
C. For any OSPF routes redistributed into EIGRP, the metric components include a value equivalent to 100 microseconds of delay.
D. No subnets of network 10.0.0.0 will be redistributed due to the omission of the subnets parameter.
第2题：
A. Receive - only
B. Stub
C. Static
D. Summary
E. Connected
F. Dynamic
第3题：
How can a Ezonexam administrator determine if a router has been configured when it is first powered up?
A．A configured router prompts for a password
B．A configured router goes to the privileged mode prompt
C．An un configured router goes into the setup dialog
D．An un configured router goes to the enable mode prompt
第4题：
A company has a small network,consisting of a single switch and a single router.The switch has been configured with two vlans,and route-on-a-stick is being configured on the router for inter-vlan routing.A trunk is configured to connect the switch to the router.What is the minimum number of router subinterfaces that are required for all the vlans to communicate?（）
A. one
B. three
C. two
D. zero
第5题：
A. The route to 10.2.0.0/16 was redistributed into EIGRP.
B. A default route has been redistributed into the EIGRP autonomous system.
C. R1 is configured with the ip summary - address command.
D. R1 is sourcing a n external EIGRP route from Null0.
E. The router at 10.1.1.2 is configured with the ip default - network 0.0.0.0 command.
F. R1 is configured with the variance command.
第6题：
Refer to the exhibit. EIGRP has been configured on router D. Router C is performing mutual redistribution between EI GRP and OSPF. While verifying that the redistribution is functioning properly, you discover that while router C has all of the EIGRP routes in its routing table, router A does not have any routes from the EIGRP domain. What on router C may be the cause o f the problem?（）
A. The no auto - summary command needs to be added under router eigrp 1
B. The subnets keyword was not included in the redistribute command under router ospf 1
C. The metric specified for the redistributed EIGRP routes is too large; m aking the EIGRP routes unreachable by router A
D. The default - information originate command needs to be added under router ospf 1
E. The administrative distance of either OSPF or EIGRP must be changed so that EIGRP has a higher administrative distanc e than OSPF
第7题：
A.When manual summarization is configured, the router immediately creates a route that points to null0 interface
B.Manual route summarization is configured in router configuration mode when the router is configured for EIGRP routing
C.Manual route summarization is configured on the interface
D.The ip summary - address eigrp command generates a default route with an administrative distance of 5
E.When manual summarization is configured, the summary route will use the metric of the largest specific metric of the summary routes
F.The ip summary - address eigrp command generates a default route with an administrative distance of 90
第8题：
Router R1 has been configured with the redistribute ospf 1 route - map fred command under router eigrp 1. The route map named fred needs to be configured to match routes to d etermine which routes are redistributed into EIGRP.Which of the following answers lists an item that cannot be matched by route map fred?（）
A. Subnet number
B. Next - hop router IP address of the route
C. Whether the route is an E1 or E2 route
D. The ro ute‘s tag
E. The number of router hops between the router and the subnet
第9题：
A. The no auto - summary command has not been issued under the EIGRP process on both routers.
B. Interface E0 on router R1 has not been configured with a secondary IP address of 10.1.2.1/24.
C. EIGRP cannot exchange routing updates with a neighbor‘s router interface that is configured with tw o IP addresses.
D. EIGRP cannot form neighbor relationship and exchange routing updates with a secondary address.
第10题：
A network administrator is troubleshooing an EIGRP problem on a router and needs to confirm the IP addresses of the devices with which the router has established adjacency. The retransmit interval and the queue counts for the adjacent routers also need to be checked. What command will display the required information?（）
A. Router# show ip eigrp adjacency
B. Router# show ip eigrp topology
C. Router# show ip eigrp interfaces
D. Router# show ip eigrp neighbors