You are troubleshooting a routing issue and need to check the hop-by-hop path to the 10.10.10.10 destination. Which three commands would display the path?（）A、user@router# traceroute 10.10.10.10B、user@router> ping record-route 10.10.10.10C、user@router>trac

题目

You are troubleshooting a routing issue and need to check the hop-by-hop path to the 10.10.10.10 destination. Which three commands would display the path?（）

A、user@router# traceroute 10.10.10.10
B、user@router> ping record-route 10.10.10.10
C、user@router>traceroute 10.10.10.10
D、user@router# run traceroute 10.10.10.10
E、user@router# ping record-route 10.10.10.10

如果没有搜索结果或未解决您的问题，请直接联系老师获取答案。

相似问题和答案

第1题：

You are troubleshooting a WAN connection for TestKing, and on the router you execute the, "debug ppp authentication" command, and view the following output:What kind of handshake was used for the PPP authentication?（）

A. one-way

B. two-way

C. three-way

D. No handshakes required during authentication

E. None of the above

参考答案：C

第2题：

When you are troubleshooting an ACL issue on a router,which command can help you to verify which interfaces are affected by the ACL?()

A.show ip access-list

B.show access-list

C.list ip interface

D.show interface

E.show ip interface

参考答案：E

第3题：

Your network contains a server named Server1 that runs Windows Server 2008 R2.You discover that the server unexpectedly shut down several times during the past week.You need to identify what caused the shutdowns and which software was recently installed.What should you click from Action Center？（）

A. Maintenance, and then View reliability history

B. Troubleshooting, and then Programs

C. Troubleshooting, and then System and Security

D. Troubleshooting, and then View history

参考答案：A

第4题：

You are troubleshooting a Catalyst 5000 trunk in the network. What should you do if there’s adisagreement about the VLANs configured to use the trunk？（）

A、Reload the active VLAN configuration
B、Clear the affected port and bring it up again
C、Explicitly set the trunk for the VLAN to be on
D、Remove all the VLANs set

正确答案:B

第5题：

You need to uninstall a Windows update from a computer that runs Windows 7. Which Control Panel itemshould you use?（）

A、Administrative Tools
B、Programs and Features
C、Sync Center
D、Troubleshooting

正确答案:B

第6题：

While troubleshooting a network connectivity issue, you suspect that a router may be missing a route, or may be receiving bad routing information to a destination. What command should you issue to view the route that the router will use to reach a given destination?（）

A. ping

B. trace

C. show ip route

D. show interface

E. show cdp neighbors

参考答案：C

第7题：

At which stage of the Cisco Lifecycle Services approach would you recommend supporting and troubleshooting the system？（）

A、 Preparation
B、 Planning
C、 Design
D、 Implementation
E、 Operation
F、 Optimization

正确答案:E

第8题：

Without calling JTAC, which two troubleshooting tools on a MAG Series device would you use to identify the cause of an authentication failure?()

A. Remote Debugging

B. System Snapshot

C. User Access logs

D. Policy Tracing

参考答案：C, D

第9题：

Your network is suffering from regular outages. After troubleshooting， you learn that the transmit lead of a fiber uplink was damaged. Which two features can prevent the same issues in the future？（）

A、root guard
B、loop guard
C、BPDU guard
D、UDLD
E、BPDU skew detection

正确答案:B,D

第10题：

You are troubleshooting a problem with a Cisco 7920 wireless IP phone on a standalone WLAN.The phone rings but， when you answer， the call is dropped. What may cause this problem？（）

A、The minimum data rate is not set to 11 Mbps.
B、An address resolution protocol is enabled.
C、Publicly Secure Packet forwarding is enabled.
D、The access point is set to the least congested channel.

正确答案:C

You are troubleshooting a routin

题目

相似问题和答案

更多相关问题

相关内容