违法和不良信息举报 联系客服
免费注册 登录

A just announced two-port Ethernet card has been installed o

题目
单选题
A just announced two-port Ethernet card has been installed on a system and it is not recognized. On the HMC the slot shows empty. The device driver has been installed and cfgmgr runs normally. What is the most appropriate action to solve this problem?（）
A

Update the HMC software

B

Update the system firmware

C

Re-install the device driver

D

Flash update the two-port card

参考答案和解析
正确答案： A
解析： 暂无解析
如果没有搜索结果或未解决您的问题，请直接 联系老师 获取答案。
相似问题和答案

第1题：

You are the network administrator for Test King. All network servers run Windows Server 2003. A server named TestKingSrv hosts applications for network users.TestKingSrv contains a motherboard that can support two CPUs. One CPU is currently installed. TestKingSrv has 512 MB of RAM and a single 36 - GB integrated device electronics (IDE) hard disk. It has a 10 MB Ethernet card connected to a 10/100 Mb switch.After TestKingSrv is in use for five months, network users report unacceptable response times on their applications.You open System Monitor on TestKingSrv and see the information shown in the following table.You need to improve the performance of Server 1.What should you do?（）

A. Add an additional CPU.

B. Add an additional 512 MB of RAM.

C. Replace the existing hard disk with a faster one.

D. Replace the 10-Mb Ethernet card with a 100-Mb Ethernet card.


参考答案：C

第2题：

The technician has suspicions that a browser has been hijacked. Which of the following should the technician look for in this situation?（）

  • A、A new default gateway has been setup.
  • B、A new Internet shortcut has been added.
  • C、A new web browser has been installed and is now the default.
  • D、A proxy server has been enabled.

正确答案:D

第3题：

An administrator has just installed a new NIC into the server. The system POSTs fine and the NIC is recognized by the OS, but it does not receive an IP address. Which of the following is the MOST likely cause of this?（）

A. The NIC is not on the HCL.

B. The driver is incorrect on the server.

C. The patch cable has not been seated properly.

D. The NIC is not seated properly.


参考答案：C

第4题：

A technician installed a new video card on a motherboard which has onboard video. When the monitor was plugged into the new card and the power was turned on, a no signal message appeared on the monitor. Which of the following is MOST likely the issue?（）

  • A、In the BIOS, the onboard video adapter must be disabled.
  • B、The video resolution is set too high.
  • C、The LCD panel is defective.
  • D、The drivers for the new video card must be installed before installing the card.

正确答案:A

第5题：

An administrator has just installed a new NIC into the server. The system POSTs fine and the NIC is recognized by the OS, but it does not receive an IP address. Which of the following is the MOST likely cause of this?（）

  • A、The NIC is not on the HCL.
  • B、The driver is incorrect on the server.
  • C、The patch cable has not been seated properly.
  • D、The NIC is not seated properly.

正确答案:C

第6题：

Which of the following describes the advantage of using Fibre Channel over Ethernet （FCoE） in POWER6 and POWER7 Blades？（）

  • A、The FCoE card provides both LAN and fibre channel function from a single card on the blade. 
  • B、The FCoE advanced technology removes the need for any BladeCenter switching to support this function.
  • C、Component reliability on the fibre channel over Ethernet is higher than on regular Ethernet and fibre channel adapters.
  • D、The AIX device driver for FCoE has been completely rewritten for the current adapter， eliminating errors and performance issues.

正确答案:A

第7题：

On a Cisco Aironet 802.11 a/b/g wireless LAN client adapter，the status LED and activity LED are alternating on and off. What does this indicate？（）

  • A、The client card has failed.
  • B、The client card is not associated to the network.
  • C、The driver has been installed incorrectly.
  • D、The client card has awakened from power-save mode.

正确答案:B

第8题：

A base operating system has just been installed, successfully rebooted, and the user is now logged in as root. The user wants the server software bundle installed, but has additional software that must be installed with the bundle. Which of the following procedures should be performed to complete the installation?（）

A.Add the software to /usr/sys/inst.images

B.Update the bundle file in /usr/sys/inst.images

C.Install the bundle filelists and run update all

D.Add the software to the bundle file in /usr/sys/inst.data/sys_bundles


参考答案：D

第9题：

An administrator is up grading the back up server from a single tape drive to a SCSI tape library. The library has been unpackaged， mounted， and the library drivers installed.  Which of the following items should the administrator have to connect the device to the backup server？（）

  • A、 SCSI cable
  • B、 SCSI interface adapter on the tape library
  • C、 SCSI termination card on the server
  • D、 iSCSI cable

正确答案:A

第10题：

A technician has just installed an upgraded graphics card. The computers power turns off before itfinishes booting. Which of the following is the cause of the problem? （）

  • A、The monitor cannot display the increased resolution that is a feature of the new graphics card.
  • B、The power supply does not provide enough wattage to power the new graphics card.
  • C、The new graphics card is incompatible with the existing processor.
  • D、The computer does not have enough RAM to support the new graphics card.

正确答案:B

更多相关问题
相关内容