4
16
20
32
第1题：
Refer to the exhibit. OSPF has been configured on all routers in the network. However, router R1 does not receive a default route to router R2 as in tended. Which configuration change would ensure that R1 would receive a default route from R2? （）
A. Add the area 1 stub command on routers R1.
B. Add the always keyword to the default - information originate configuration command on router R2.
C. Remov e the default information originate configuration command from router R2 and place it on router R1.
D. Add the ip route 5.0.0.0 255.255.255.0 0.0.0.0 command to router R2.
第2题：
The TestKing.com administrator has made changes to the router configuration but cannot remember if those changes were saved. Which of the following commands allows the administrator to see the configuration that will load when the router is restarted?（）
第3题：
A. IDE Auto Detect
B. BIOS Administrator Password
C. Advanced Configuration and Power Interface
D. Plug and Play
第4题：
A system administrator installed a new switch using a script to configure it. IP connectivity was tested using pings to SwitchB. Later attempts to access NewSwitch using Telnet from SwitchA failed. Which statement is true？（）
第5题：
Company.com has recently received a new p5-570 in the data center and intends to Micro-Partition the server. In which order should installation steps be taken？（）
第6题：
The TestKing.com administrator has made changes to the router configuration but cannot remember if those changes were saved. Which of the following commands allows the administrator to see the configuration that will load when the router is restarted?（）
A. TestKingC# show memory
B. TestKingC# show startup-config
C. TestKingC# show running-config
D. TestKingC# show restart
第7题：
An administrator notes that after a recent power outage, some open files were corrupted on one affected file server. Which of the following items should the administrator consider to determine the cause of this corruption?（）
第8题：
A.Power 595
B.Power 560
C.Power 570
D.Power 550
第9题：
An administrator has implemented the following LPARs on a Power 570 with 32 GB memory with 512 MB remaining for allocation： LPAR 1 memory ： min = 10 GB des = 15 GB max = 24 GB LPAR 2memory ： min = 10 GB des = 15 GB max = 24 GB The administrator receives a request to add 2 GB to LPAR 1. The only way to do this is by moving memory from LPAR 2 to LPAR 1. The administrator attempts to move the memory， but the operation fails. The administrator can however allocate 512 MB that is free to LPAR 1 on the 570. What is the most likely cause of this failure when dynamically moving memory？（）
第10题：
An administrator notes that after a recent power outage， some open files were corrupted on oneaffected file server. Which of the following items should the administrator consider to determine the cause of this corruption？（）