Router R1, a branch router, connects to the Internet using D

题目
单选题
Router R1, a branch router, connects to the Internet using DSL. The engineer plans to use a configuration with a dialer interface. The answers list a feature and interface on which the feature could be configured. Which combinations accurately describe the interface under which a feature will be configured?()
A

PPP on the ATM interface

B

VPI/VCI on the dialer interface

C

IP address on the ATM interface

D

CHAP on the dialer interface

如果没有搜索结果或未解决您的问题,请直接 联系老师 获取答案。
相似问题和答案

第1题:

Router R1 sits at an Enterprise branch office, using the Internet for its only connectivity back to the rest of the EnterprisE.Which of the following is not a ben efit of using an IPsec tunnel for packets sent through the Internet, between R1 and the rest of the Enterprise?()

A. Privacy

B. Authentication

C. Allows using an IGP between R1 and the Enterprise

D. Secure communications


参考答案:C

第2题:

Refer to the exhibit. Routers R1 and R2 have established a neighbor relationship and are exchanging routing information. The network design requires that R1 r eceive routing updates from R2, but not advertise any routes to R2. Which configuration command sequence will successfully accomplish this task? ()

A. R1(config)# router eigrp 1 R1(config - router)# passive - interface serial 0

B. R1(config)# access - list 2 0 deny any R1(config)# router eigrp 1 R1(config - router)# distribute - list 20 out serial 0

C. R2(config)# access - list 20 permit any R2(config)# router eigrp 1 R2(config - router)# distribute - list 20 in serial 0

D. R1(config)# access - list 20 permit any R 1(config)# router eigrp 1 R1(config - router)# distribute - list 20 in serial 0

E. R2(config)# access - list 20 deny any R2(config)# router eigrp 1 R2(config - router)# distribute - list 20 out serial 0

F. R2(config)# router eigrp 1 R2(config - router)# passive - interface serial 0


参考答案:B

第3题:

Router R1, a branch router, connects to the Internet using DSL. Some traffic flows through a GRE and IPsec tunnel, over the DSL connection, destined for an Enterprise network.Which of the following answers best describes the router‘s logic that tells the router, for a given packet, to apply GRE encapsulation to the packet?()

A. When the packet received on the LAN interface is permitted by the ACL listed on the tunnel greacl command under the incoming interface

B. When routing the packet, matching a route whose outgoing interface is the GRE tunnel interface

C. When routing the packet, matching a route whose outgoing interface is the IPsec tunnel interface

D. When permitted by an ACL that was referenced in the associated crypto map


参考答案:B

第4题:

Enterprise Router R1, in ASN 1, connects to ISP Router I1, ASN 2, using eBGP. The single serial link b etween the two routers uses IP addresses 10.1.1.1 and 10.1.1.2, respectively. Both routers use their S0/0 interfaces for this link. Which of the following commands would be needed on R1 to configure eBGP?()

  • A、router bgp 2
  • B、router bgp 1
  • C、neighbor 10.1 .1.2 remote - as 2
  • D、neighbor 10.1.1.2 Update - source 10.1.1.1
  • E、neighbor 10.1.1.2 Update- source S0/0

正确答案:B,C

第5题:

What is themostlikelyreasonforthedispartlybetweentheactualnetworknumbersatthebranchesandtheroutesintheroutingtableonGateway-Router?()

A.Branch-Router2isconfiguredtosendbothRIPv1andRIPv2updates.

B.Gateway-RouterisconfiguredtoonlyreceiveRIPv2updates.

C.Gateway-routerisconfiguredtoreceiveonlyRIPv1updates.

D.Branch-Router1isconfiguredtoonlysendRIPv1updates.


参考答案:D

第6题:

Router R1 connects to a Frame Relay cloud using a multipoint subinterface, with ten PVCs associated with the subinterface.What command would make this router not use a DR, and dynamically discover OSPF neighbors?()

A. ip ospf network broadcast

B. ip ospf network non - broadcast

C. ip ospf network point - to - multipoint

D. ip ospf network point - to - multipoint non - broadcast


参考答案:C

第7题:

Refer to the exhibit. Router R1 is connected to networks 172.1 6.1.0 /26 and 172.16.1.64 /27. On the basis of the partial output in the exhibit, which statement is true? ()

A. Router R1 will deny the 172.16.1.0/26 route while permitting the 172.16.1.64/27 route to be advertised.

B. Router R1 will advertise both rou tes.

C. Router R1 should be reconfigured with an ACL instead of an ip prefix - list command.

D. Router R1 will deny the 172.16.1.0/27 route while permitting the 172.16.1.0/26 route to be advertised.


参考答案:D

第8题:

Router R1, a branch router, connects to the Internet using DSL. The engineer plans to use a configuration with a dialer interface. The answers list a feature and interface on which the feature could be configured.Which combinations accurately describe the interface under which a feature will be configured?()

A. PPP on the ATM interface

B. VPI/VCI on the dialer interface

C. IP address on the ATM interface

D. CHAP on the dialer interface


参考答案:D

第9题:

WhatisthemostlikelyreasonforthedispartlybetweentheactualnetworknumbersatthebranchesandtheroutesintheroutingtableonGateway-Router?()

A.Branch-Router2isconfiguredtosendbothRIPv1andRIPv2updates.

B.Gateway-RouterisconfiguredtoonlyreceiveRIPv2updates.

C.Gateway-routerisconfiguredtoreceiveonlyRIPv1updates.

D.Branch-Router1isconfiguredtoonlysendRIPv1updates.


参考答案:D

第10题:

You administer a network that uses two routers, R1 and R2, configured as an HSRP group to  provide redundancy for the gateway. Router R1 is the active router and has been configured as  follows:   R1#configure terminal   R1(config)#interface fa0/0   R1(config-if)#ip address 10.10.0.5 255.255.255.0   R1(config-if)#standby 1 priority 150   R1(config-if)#standby preempt delay minimum 50   R1(config-if)#standby 1 track interface fa0/2 15   R1(config-if)#standby 1 ip 10.10.0.20   Which of the following describes the effect the standby preempt delay minimum 50 command will  have on router R1?()

  • A、 The HSRP priority for router R1 will increase to 200.
  • B、 Router R1 will become the standby router if the priority drops below 50.
  • C、 The HSRP priority for router R1 will decrease to 50 points when Fa0/2 goes down.  
  • D、 Router R1 will wait 50 seconds before attempting to preempt the active router.

正确答案:D

更多相关问题