A router learns about a remote network from EIGRP, OSPF, and

题目
单选题
A router learns about a remote network from EIGRP, OSPF, and a static route. Assuming all routing protocols are using their default administrative distance, which route will the router use to forward data to the remote network?()
A

The router will use the static route.

B

The router will use the OSPF route.

C

The router will use the EIGRP route.

D

The router will load balance and use all three routes.

如果没有搜索结果或未解决您的问题,请直接 联系老师 获取答案。
相似问题和答案

第1题:

Refer to the exhibit. EIGRP had converged in AS 1 when the link between router R1 and R2 went down. The console on router R2 generated the following messages:*Mar 20 12:12:06: %DUAL - 5NBRCHANG E: IP - EIGRP 1: Neighbor 10.1.4.3 (Serial0) is down: stuck in active*Mar 20 12:15:23: %DUAL -3- SIA: Route 10.1.1.0/24 stuck - in - active state in IP - EIGRP 1.Cleaning up The network administrator issued the show ip eigrp topology active command on R2 to check the status of the EIGRP network.Which statement best describes the reason for the error messages?()

A. Incorrect bandwidth configuration on router R3 prevents R2 from establishing neighbor adjacency.

B. Incorrect bandwidth configuration on router R 5 prevents R2 from establishing neighbor adjacency.

C. Router R3 did not reply to the query about network 10.1.1.0/24 sent by router R2 .

D. Router R5 did not reply to the query about network 10.1.1.0/24 sent by router R2 .


参考答案:C

第2题:

Refer to the exhibit. Router B is performing bidirectional redistribution between EIGRP an d OSPF.The network 10.100.1.0/24 should not be reachable from the 10.100.9.0/24 network. However, it needs to be reachable from any network within the EIGRP domain. All other networks should be seen in both domains. Which change to router B would accom plish these goals?()

A. Under the EIGRP process, insert the distribute - list block_net_1 out ospf 1 command.

B. Under the OSPF process, insert the distribute - list block_net_1 in serial1/0 command.

C. Under the EIGRP process, insert the distribute - list block_net_1 in serial1/0 command.

D. Under the OSPF process, insert the distribute - list block_net_1 out eigrp 1 command.


参考答案:D

第3题:

Which OSPF router type summarizes network advertisements from one OSPF area into another?()

A.A

B.B

C.C

D.D


参考答案:A

第4题:

Refer to the exhibit. EIGRP is configured on all routers in the network. On a basis of the show ip eigrp topology output provided, what conclusion can be deri ved? ()

A.Router R1 is waiting for a reply from the neighbor 10.1.2.1 to the hello message sent out inquiring for a second successor to network 10.6.1.0/24

B.Router R1 can send traffic destined for network 10.6.1.0/24 out of interface FastEthernet0/0

C.Router R1 is waiting for a reply from the neighbor 10.1.2.1 to the hello message sent out before it declares the neighbor unreachable

D.Router R1 is waiting for a reply from the neighbor 10.1.2.1 in response to the query sent out about network 10 .6.1.0/24


参考答案:D

第5题:

After implementing EIGRP on your network, you issue the show ip eigrp traffic command on router C. The following output is shown:What can you conclude about this network? ()

A. The network has been stable for at least the last 45 minutes

B. There is a flapping link or interf ace, and router C knows an alternate path to the network

C. There is a flapping link or interface, and router A does not know an alternate path to the network

D. EIGRP is not working correctly on router C

E. There is not enough information to make a determination


参考答案:A

第6题:

Refer to the exhibit. EIGRP has been configured on router D. Router C is performing mutual redistribution between EI GRP and OSPF. While verifying that the redistribution is functioning properly, you discover that while router C has all of the EIGRP routes in its routing table, router A does not have any routes from the EIGRP domain. What on router C may be the cause o f the problem?()

A. The no auto - summary command needs to be added under router eigrp 1

B. The subnets keyword was not included in the redistribute command under router ospf 1

C. The metric specified for the redistributed EIGRP routes is too large; m aking the EIGRP routes unreachable by router A

D. The default - information originate command needs to be added under router ospf 1

E. The administrative distance of either OSPF or EIGRP must be changed so that EIGRP has a higher administrative distanc e than OSPF


参考答案:B

第7题:

After implementing EIGRP on your network, you issue the show ip eigrp traffic command on router C. The following output is shown:What information can you determine about this network?()

A. The network is stable

B. There is a flapping link or interface, and router C knows an alternate path to the network

C. There is a flapping link or interf ace, and router C does not know an alternate path to the network

D. EIGRP is not working correctly on router C

E. There is not enough information to make a determination


参考答案:B

第8题:

What are two examples of RE exception traffic?()

A. BGP updates that travel through the local router and are destined for a remote router.

B. OSPF hello packets that are sent from a remote router and are destined for the local router.

C. Telnet traffic that is sent from a remote host and is destined for the local router.

D. Telnet traffic that travels through the local router and is destined for a remote end host.


参考答案:B, C

第9题:

Refer to the above exhibit. Why are the EIGRP neighbors for this router not learning the routes redistributed from OSPF?()

A. Redistribution must be enabled mutually (in both directions) to work correctly.

B. auto - summary causes the OSPF routes redistributed into EIGRP to be summarized; thus the OSPF network 116.16.34 is summarized to 116.3 4.0.0, which is already covered by the EIGRP protocol.

C. Default metrics are not configured under EIGRP.

D. Both routing protocols must have unique autonomous system numbers for redistribution to function correctly.


参考答案:C

第10题:

A router has learned three possible routes that could be used to reach a destination network. One route is from EIGRP and has a composite metric of 20514560. Another route is from OSPF with a metric of 782. The last is from RIPv2 and has a metric of 4. Which route or routes will the router install in the routing table?()

A. the OSPF route

B. the EIGRP route

C. the RIPv2 route

D. all three routes

E. the OSPF and RIPv2 routes


参考答案:B

更多相关问题