Routing Engine on M10i
Physical Interface Card on M7i
fan tray on J-series routers
Physical Interface Modules on J6300 router
第1题：
Router R1, a branch router, connects to the Internet using DSL. The engineer plans to use a configuration with a dialer interface. The answers list a feature and interface on which the feature could be configured.Which combinations accurately describe the interface under which a feature will be configured?（）
A. PPP on the ATM interface
B. VPI/VCI on the dialer interface
C. IP address on the ATM interface
D. CHAP on the dialer interface
第2题：
A. Application of up to three access lists per protocol to a single interface.
B. No more than two access lists per interface.
C. One access list may be configured per direction for each Layer 3 protocol configured on an interface.
D. The maximum number allowed varies due to RAM availability in the router.
E. An infinite number of access lists that can be applied to an interface, from most specific to most general.
F. Cisco IOS allows only one access list to an interface.
第3题：
A. from a zone to the router itself
B. from a zone to the same zone
C. from a zone to a different zone
D. from one interface to another interface
第4题：
Which three causes could prevent a host from getting an IPv6 address with stateless autoconfiguration？（）
第5题：
Router R1, a branch router, connects to the Internet using DSL. The engineer plans to use a configuration with a dialer interface. The answers list a feature and interface on which the feature could be configured. Which combinations accurately describe the interface under which a feature will be configured?（）
第6题：
A. The ABR must have multiple interfaces connected to the backbone areA
B. An ABR is a router with two interfaces, each connected to a different nonbackbone areA
C. The only requirement to be considered an ABR is at least one interface connected to the backbone areA
D. An ABR must have at least one interface in the backbone area plus at least one other interface in a nonbackbone areA
第7题：
Which of these statements accurately identifies how Unicast Reverse Path Forwarding can be employed to prevent the use of malformed or forged IP sources addresses？（）
第8题：
A. This command is applied to the core router facing interface.
B. This command is applied to the customer facing interface.
C. The 4 is locally significant and identifies the layer 2 circuit.
D. The 4 must match exactly on the peer router configuration on the remote end.
第9题：
Which of the following statements regarding the use of multiple access lists are valid when configuring a single interface on a Cisco router?（）
第10题：
Which of the following is true about an OSPF area border router (ABR)?（）