The autoconfig command is missing from the router interface.
IPv6 multicast routing is not enabled on the router interface.
IPv6 unicast routing is not enabled on the router interface.
The router interface is configured with a /63 mask.
The router interface is configured with a /65 mask.
第1题:
You‘re the systems administrator at Testing, and you create the following access control lists.You then enter the command "ip access-group 101 in" to apply access control list 101 to router TK1s e0 interface.Which of the following Telnet sessions will be blocked as a result of your access lists?()
A. Telnet sessions from host A to host 5.1.1.10
B. Telnet sessions from host A to host 5.1.3.10
C. Telnet sessions from host B to host 5.1.2.10
D. Telnet sessions from host B to host 5.1.3.8
E. Telnet sessions from host C to host 5.1.3.10
F. Telnet sessions from host F to host 5.1.1.10
第2题:
The access control list shown in the graphic has been applied to the Ethernet interface of router R1using the ip access-group 101 in command.Which of the following Telnet sessions will be blocked by this ACL?()
A.from host PC1 to host 5.1.1.10
B.from host PC1 to host 5.1.3.10
C.from host PC2 to host 5.1.2.10
D.from host PC2 to host 5.1.3.8
第3题:
A. The local host will respond to ICMP echo-request packets from 192.168.53.10.
B. The local host will respond to UDP port 53 requests from 192.168.1.25.
C. The local host can send any packet of any type to host 172.16.1.1.
D. The local host will accept any packet of any type from host 172.16.1.1.
E. The local host can send packets to UDP port512 on server 192.168.53.10.
第4题:
Which command can be used to filter a RIPv6 route from getting installed in the routing table?()
第5题:
Which two statements are true about using IPv4 and IPv6 simultaneously on a network segment? ()
第6题:
A. statically map IPV4 address to IPV6 addresses
B. configuration IPv4 tunnels between IPV6 islands
C. use DHCPv6 to map IPV4 addresses to IPV6 addresses
D. use proxying and translation to translate IPV6 packets into IPV4 packets
E. configure IPV6 directly
F. enable dual-stack routing
第7题:
Flame screens are used to ______.
A.contain flammable fumes
B.protect firefightiers from flames
C.prevent flames from entering tanks
D.keep flame and sparks from getting out of an engine’s exhaust system
第8题:
A. Dual stack
B. NAT
C. Flow label
D. Mobile IP
E. 6to4 tunneling
F. Anycast
G. MBGP
第9题:
Which three circumstances would prevent traceroute from displaying the WAN IP addresses? ()(Choose three)
第10题:
Which three causes could prevent a host from getting an IPv6 address with stateless autoconfiguration?()