单选题An A+ Certified Technician MUST do an install on a Windows XP system from the distribution CD. However， the system does not boot from this CD. What is the MOST likely cause of this problem？（）A The CD is defective.B The CD is not bootable.C The CD-ROM d

第1题：

A technician is attempting to configure Windows XP Media Center on a desktop from a CD. The message that comes up on the screen says ‘Missing NTLDR press any key to reboot’. Which of the following should the technician do NEXT?（）

• A、Replace the video card with a compatible one.
• B、Check the Windows XP Hardware Compatibility List.
• C、Verify the boot order in the BIOS.
• D、Install Windows XP RC2 first, then upgrade to Windows XP Media Center.

第2题：

A technician is trying to load a device driver directly from the manufacturer’s CD for a PCI NIC. The operating system is Windows Vista. Windows refuses to accept the driver. Which of the following is the MOST likely cause of this problem?（）

• A、The driver CD is for Windows XP only.
• B、The technician needs to initialize the NIC first within Device Manager before installing a driver.
• C、The driver on the CD is not digitally signed.
• D、The driver is corrupt.

第3题：

第4题：

A client has tried to update the firmware of an Ethernet adapter on a p5 590, however it repeatedly fails. What is the most likely cause of this problem?（）

• A、The adapter must be taken offline prior to the firmware update
• B、The adapter must be assigned to the service partition prior to the firmware update
• C、The system has not been rebooted since the adapter was added to the Logical Partition
• D、The adapter must be dynamically removed from the Logical Partition prior to the firmware update

第5题：

A Windows XP system locks up after the GUI starts to load. The system will start in Safe Mode. TheEvent Viewer reports that a driver failed to load. Which of the following methods would help diagnose the problem? （）

• A、Enable boot logging. In Safe Mode, read the ntbtlog.txt file.
• B、In Safe Mode, run the sigverif utility.
• C、Restart the system from the OEM recovery CD; do a full restore.
• D、In Safe Mode, run the driverquery utility.

第6题：

A user reports that after configuring the BIOS to boot to the hard drive first, the system still tries to boot from the optical drive. Which of the following is the MOST likely cause?（）

• A、Optical drive
• B、Power supply
• C、CMOS battery
• D、CD-ROM disk

第7题：

A defective CD-ROM drive is replaced with a new CD-ROM drive. The new CD-ROM drive is able to read any CD that it accesses， but music CDs do not play music. What is the MOST likely cause of this problem？（）

• A、The audio cable is not connected to the drive.
• B、The ribbon cable is not connected.
• C、The power cable is not connected.
• D、The CD-ROM drivers are not installed.

第8题：

everal people in an finance customer IT department are asking for fileset updates that the  system administrator received from IBM earlier that day on CD-ROM. The system administrator created an install directory on their machine and made it available to everyone.  Which of the following commands will allow the system administrator to copy the images from an IBM update CD-ROM to the install directory（）

• A、"smit bffcreate" from the target directory
• B、"tar -xvf /dev/cd0" from the target directory
• C、"restore -xvqf /dev/cd0" from the target directory
• D、mount the cdrom on /cdrom and run "cp /cdrom/* ." from the target directory

第9题：

A technician installs a SATA controller card and moves the hard drive cable from the system board to the SATA controller. The system POSTs and the controller BIOS recognizes the hard drive but does not boot to the hard drive and start Windows. Which of the following is the MOST likely cause of the problem？（）

• A、Windows cannot be booted from a controller card.
• B、The hard drive must have Windows reinstalled because a new controller card was installed.
• C、The SATA controller card was not set as a boot device in the computer BIOS.
• D、The new controller must have the correct jumper settings for Windows mode.

第10题：

A system administrator had a disk failure on an HMC. The disk was replaced and the HMC was loaded from the Product Recovery CD. The system administrator had performed a backup to DVD of the HMC data before the system failed. After restoring the backup files, it was noticed that no profile files were restored. What is the most likely cause of this problem?（）

• A、The profile data was not initialized after restoring the backup CD
• B、The profile data was not backed up before doing the Critical Console Data backup
• C、A Critical Console Data backup was performed which backs up user data， but not profile data
• D、A Save Upgrade data was done instead of a backup Critical Console Data and the profile files were not included