问题:单选题Which statement describes the primary difference between the WX and WXC platforms?()A The WX platform has built-in hard drives.B The WXC platform has no built-in hard drives.C The WX platform uses Network Sequence Caching technology.D The WXC platform uses the Network Sequence Caching technology
查看答案
问题:多选题Which three applications are disabled for compression by default?() (Choose three.)AFTPBSSHCUDPDHTTPSETraceroute
问题:多选题Which two configurations are made using the QoS Setup Wizard? ()(Choose two.)AAssign applications to traffic classes.BUse ToS/DSCP values for traffic classes.CExclude subnets from QoS management.DSelect dedicated vs. over-subscribed circuits.
问题:多选题What happens when you enable QoS bandwidth detection? ()(Choose two.)ACircuit speed is reduced by 2% for overhead.BWAN speed can be configured to the LAN speed.CBandwidth is adjusted based on minimum and maximum settings.DWAN bandwidth is detected based on acknowledgement of metapackets.
问题:多选题Which three ports does a WX device use for control traffic purposes?() (Choose three.)A3577 UDPB3578 UDPC3678 UDPD3577 TCPE3578 TCP
问题:多选题Which three circumstances would prevent traceroute from displaying the WAN IP addresses? ()(Choose three)AThe WAN link is down.BIPSec is enabled on the WX.CTraceroute is enabled for compression.DThe network is configured using static routes.EThe local and remote cables are accidentally swapped.
问题:多选题What are three key pre-installation/configuration considerations when deploying a WX device?() (Choose three.)AcablingBcommunity topologyCrequires a license keyDrequires two IP addressesEregistration server designation
问题:单选题Why is SNMPv2 used to monitor the WX platform?()A SNMPv1 is read-only on WX devices.B SNMPv1 is not supported by WX devices.C SNMPv2 supports both 32- and 64-bit counters.D SNMPv2 does put and get commands to WX devices.
问题:多选题What happens when you enable QoS bandwidth detection? ()(Choose two.)ACircuit speed is reduced by 2% for overhead.BWAN speed can be configured to the LAN speed.CBandwidth is adjusted based on minimum and maximum settingsDWAN bandwidth is detected based on acknowledgement of metapackets.
问题:单选题How do you verify connectivity between the default gateway and a WX device?()A Check the WX device remote interface and verify that the status is up.B From the WX device, ping the default gateway to make sure it is reachable.C In WebView, check the service tunnel status under Compression > Basic > Endpoints.D In WebView, check the remote routes under Compression > Advanced > Remote Routes.
问题:多选题Which two conditions will cause switch-to-wire to occur? ()(Choose two.)Aloss of powerBQoS congestionCsoftware failure occuredDWX device exceeded its license speedEtraffic does not match application definiton
问题:多选题Which three types of optimization does the WX 60 device perform when Exchange 2000 and Outlook 2000 are used in the network? ()(Choose three.)AFast Connection SetupBTCP Acceleration (AFP)CNetwork Sequence CachingDAppFlow's MAPI accelerationEMolecular Sequence Reduction
问题:单选题What is one way to escape hardware bypass mode?()A Reset the cabling.B Power cycle the device.C Bounce the service tunnels.D Unlock the device from the console.
问题:多选题Exchange acceleration is not working. Which three steps should you use to troubleshoot the problem? ()(Choose three.)ADetermine if CIFS acceleration is enabled.BDetermine if TCP Acceleration (AFP) is enabled.CDetermine if Forward Error Correction is enabled.DDetermine if any tunnel bounces occurred recently.EDetermine whether both Exchange server and clients are running version 2003.
问题:多选题What are two instances when a WX device route carves? ()(Choose two.)AIt occurs every 29 hours.BPacket interception mode is enabled.CThe host is unreachable on the local subnet.DThe subnet is unreachable using the advertised router.
问题:多选题Which two functions are performed in Quick Setup?() (Choose two.)Aoperating modeBauto-deploymentCspeed and duplex settingsDregistration server designation
问题:多选题Which three applications or protocols are accelerated by AppFlow?() (Choose three.)AUNIX NFS protocolBWeb-based e-mailCSecure Sockets LayerDMicrosoft's Common Internet File SystemEMicrosoft's Messaging Application Programming Interface
问题:多选题What are two types of WebView monitoring statistics on the WX/WXC platforms?() (Choose two.)ALANBQoSCtrafficDIPSec
问题:多选题Which two patented or patent-pending compression and caching technologies are used for WX/WXC devices?()(Choose two.)ANetwork Sequence Caching (NSC)BMolecular Sequence Caching (MSC)CNetwork Sequence Reduction (NSR)DMolecular Sequence Reduction (MSR)
问题:多选题Click the Exhibit button.Which two are correct about CIFS acceleration based on the exhibit?() (Choose two.)AThe statistics show savings for all CIFS traffic.BThe traffic transfered over 4,000 seconds faster.CThere was a bandwidth savings of almost 68.9%.DThe acceleration is only working for 68.9% of the traffic