Where should known problem areas in the site survey be docum

第1题：

For an active Cisco Unified Wireless IP Phone 7921G 5 GHz site survey， what are the mostappropriate client test settings to use with the AirMagnet site survey tool？（）

• A、100 mW， 24 Mb/s
• B、100 mW， 18 Mb/s
• C、25 mW， 18 Mb/s
• D、3.2 mW， 54 Mb/s

第2题：

You are troubleshooting an OSPF problem where external routes are not showing up in the OSPF database. Which two options a re valid checks that should be performed first to verify proper OSPF operation?（）

• A、Are the ASBRs trying to redistribute the external routes into a totally stubby area?
• B、Are the ABRs configured with stubby areas?
• C、Is the subnets keyword being used with the redistribution command?
• D、Is backbone area (area 0) contiguous?
• E、Is the CPU utilization of the routers high?

第3题：

第4题：

Which statement regarding the site-survey process is correct？（）

• A、In a multifloor building， the access point layout from the survey of one floor can be directly applied to the remaining floors
• B、Access points can be installed in the same place on every floor， without worrying about co-channelinterference
• C、You can survey with a Cisco AIR-ANT5959 in a plenum environment
• D、Identify all hazardous and restricted areas that might require extra or special survey and installationwork

第5题：

How should the transmit power on an access point and client each be set during a site survey？（）

• A、at 30mW
• B、matched to the antenna gain
• C、differing by at least 20 dBi
• D、matched to each other

第6题：

Where should known problem areas in the site survey be documented？（）

• A、nowhere （but should be discussed with the customer）
• B、on the site survey map and within the site survey text
• C、on the customers blueprints
• D、in the Cisco WCS Planning Tool

第7题：

What are two objectives of a pre-site survey walkthrough？ （）

• A、Identify potential problem areas
• B、Define intended coverage areas
• C、Access compliance with local building codes
• D、Determine the final location of APs and antennas
• E、Identify sources of RF signal attenuation and RF interference

第8题：

第9题：

Which two of these statements describe important aspects of performing a wireless site survey？ （Choose two.）  （）

• A、 An 802.11 g access point with a variety of antennas can be used in all standard site surveys.
• B、 Site surveys can be performed manually or through assisted site survey.
• C、 Channel power during testing starts at the default minimum and gradually increases to the maximum.
• D、 Overlapping access points can create performance problems.
• E、 Surveys should be done after hours in an office building or during reduced inventory levels in warehouses.

第10题：

Which is NOT part of a typical wireless site survey？（）

• A、Implementation suggestions
• B、Access point locations
• C、Security requirements
• D、Access point mounting methods