ID0
ID2
Cable select
Master
第1题:
A. ID0
B. ID2
C. Cable select
D. Master
第2题:
A PC is powered on and begins POST. The PC takes a long time when scanning for drives. The BIOS reports no hard drive can be found but the CD-ROM is identified. The technician knows that there are two hard drives on the primary EIDE controller and a CD-ROM on the secondary EIDE controller. Which of the following is the MOST likely cause of the problem?()
第3题:
A PC is powered on and begins POST. The PC takes a long time when scanning for drives. The BIOS reports no hard drive can be found but the CD-ROM is identified. The technician knows that there are two hard drives on the primary EIDE controller and a CD-ROM on the secondary EIDE controller.Which of the following is the MOST likely cause of the problem?()
A. Both hard drives have the master jumper in place.
B. One hard drive is set as master and the other slave.
C. The hard drive data cable is reversed.
D. Both hard drives have the cable select jumper in place.
第4题:
In which of the following locations would a technician set the LBA mode for a hard drive?()
第5题:
Which of the following settings is the jumper set to when installing a DVD-RW as the second deviceon an IDE cable?()
第6题:
A. Terminate the back end of the chain.
B. Set the jumper to device ID 0.
C. Terminate both ends of the chain.
D. Set the jumper to cable select.
第7题:
Which of the following will reset the BIOS settings?() (Select TWO).
第8题:
A. Remove the BIOS chip on the PC
B. Re-flash the BIOS
C. Run password cracking software on the users PC
D. Set the password clear jumper on the motherboard
第9题:
Which of the following must occur when installing SCSI devices into the server?()
第10题:
After a technician installs a new CMOS battery on a motherboard, which of the following will thetechnician have to change? ()