Automatic switchover from active to standby on primary supervisor failure
Reset of the primary supervisor.
Manual switchover from active to standby supervisor
Manual switchover from standby to active supervisor
第1题：
A. It is a route to be used when the routing protocol fails.
B. It is a route configured by an ISP that sends traffic into a corporate network.
C. It is a route used when a packet is destined for a remote network that is not listed in the routing table.
D. It is a route manually configured for a specific remote network for which a routing protocol is not configured.
E. It is used to send traffic to a stub network.
第2题：
You‘re working at TestKing as a network administrator when your MCSE assistant calls you for help. He has attempted to configure Router TK1 and incorrectly configured the router interface with a subnet broadcast address. You have to correct this by first removing the incorrect IP address and then re-entering the first usable IP address of the same subnet.How will you do this?（）
A.
B.
C.
D.
E.
第3题：
You are the network administrator setting up the IP network for a new branch office. You need at least 5 networks with 25 hosts each. You have been allocated a /24 network.Which prefix length will satisfy the given requirements?（）
A./24
B./26
C./27
D./28
第4题：
You are troubleshooting a Catalyst 5000 trunk in the network. What should you do if there’s adisagreement about the VLANs configured to use the trunk？（）
第5题：
You examine the port statistics on a Cisco Catalyst switch and notice an excessive number offrames are being dropped. Which of the following are possible reasons for the drops？（）
第6题：
You work as a network engineer at TestKing.com. TestKing users have noticed extremely slow network performance, intermittent connectivity, and connection loss. After entering the show interfaces command, you notice that the Ethernet interface is configured as 100 Mbps full-duplex and that there is evidence of late collisions. What could be the cause of this problem?（）
A. duplex mismatch
B. a routing loop
C. trunking mode mismatch
D. improperly configured root bridge
E. improperly configured static VLAN
第7题：
You are a network administrator at TestKing, Inc. and you‘re getting complaintsthat users on the TestKing2 Ethernet network can‘t access the TestKing1 site. Totroubleshoot this, you begin by looking at the Testking1 and Testking2 routerconfigurations as shown below:Based on the above output, what is the underlying cause of this problem?（）
A. Link state routing protocol is missing.
B. Incorrectly configured IP addresses
C. IGRP is incorrectly configured.
D. Frame relay is not configured.
E. None of the above
第8题：
As a network administrator, you have configured a Catalyst 6500 Series Switch with redundant supervisor engine in a CIS network. What is the result of issuing the redundancy force-switchover command on that switch?（）
A. Automatic switchover from active to standby on primary supervisor failure
B. Reset of the primary supervisor.
C. Manual switchover from active to standby supervisor
D. Manual switchover from standby to active supervisor
第9题：
You have configured the Odyssey Access Client with a profile which has the "Disable Server Verification" setting cleared.What will be the result if the device certificate on the MAG Series device has expired and the user attempts to authenticate?（）
第10题：
An administrator is configuring a Catalyst switch with VLAN information that must be automatically distributed to other Catalyst switches in the network. What conditions must be met in order for the VLANs configured on this switch to be automatically configured on the other switches?（）