A static NAT uses a one to many mapping.
A static NAT uses a many to one mapping.
A static NAT uses a many to many mapping.
A static NAT uses a one to one mapping.
第1题：
A. Static NAT
B. Dynamic NAT
C. Dynamic NAT with overload
D. Port Address Translation
E. None of the above
第2题：
A.tunneling
B.hashing
C.routing
D.NAT
第3题：
A. Static NAT can only be used with destination NAT.
B. Static NAT rules take precedence over overlapping dynamic NAT rules.
C. NAT rules take precedence over overlapping static NAT rules.
D. A reverse mapping is automatically created.
第4题：
A Cisco router has been configured with the following command:IP nat pool nat-test 192.168.6.10 192.168.6.20 netmask 255.255.255.0his is an example of what type of NAT?（）
第5题：
Which of the following commands will remove all dynamic entries for a router’s NAT table？（）
第6题：
A. Static NAT
B. Port loading
C. NAT Overloading
D. Dynamic NAT
E. None of the above
第7题：
Which one of the following varieties of NAT utilizes different ports to map multiple IP addresses to a single globally registered IP address?（）
第8题：
A. interface-based source NAT
B. source NAT with address shifting
C. source NAT using static source pool
D. interface-based source NAT without PAT
E. source NAT with address shifting and PAT
第9题：
Which term describes the process of encapsulating IPv6 packets inside IPv4 packets?（）
第10题：
Given the topology of a server （with IP 209.165.202.150） protected behind the inside interface of an ASA/PIX，and the Internet on the outside interface. Users on the Internet need to access the server at any time， but the firewall administrator does not want to NAT the address of the server - since itis currentlya public address. Which of the following commands can be used to accomplish this？ （）