A single SAN port channel can have both Fibre Channel and virtual Fibre Channel interfaces.
SAN port channels can include up to 16 interfaces.
SAN port channels distribute traffic across all links in the port channel when source ID and destination ID load balancing are used.
The links in SAN port channels can be connected to different sets of switches.
The On mode of operation means ports only operate as part of a SAN port channel or remain inactive.
第1题：
In a Cisco Unified Computing System， where are SAN port channels connected to？（）
第2题：
You examine the port statistics on a Cisco Catalyst switch and notice an excessive number offrames are being dropped. Which of the following are possible reasons for the drops？（）
第3题：
In your database, the flash recovery area (FRA) is configured as the default for RMAN backups. You executed the following commands to configure the settings in RMAN:Which statement is true about the outcome?（）
A. Only one channel is allocated and the backup is created in the flash recovery area
B. Only one channel is allocated and the backup is created in the destination specified for channel
C. Two channels are allocated and backup sets are created in the destinations specified for channels 1 and 2
D. Three channels are allocated and backup sets are created in the destinations specified for channels 1, 2, and FRA
第4题：
Which statement is true about the frequency of OSPF LSA transmissions？（）
第5题：
Which two statements about SAN port channels configured on Cisco Nexus 5000 Series switches are true？ （）
第6题：
What is the use of NPV in Cisco Unified Computing Systems？ （）
第7题：
Which statement ab0ut VLANs in a Cisco UCS is true?（）
第8题：
A. when a packet is received from an 802.1Q trunk,the vlan id can be determined from the source MAC address table.
B. unkown unicast frames are retransmitted only to the ports that belong to the same vlan
C. ports between switches should be configured in access mode so that vlans can span across the ports
D. broadcast and multicast frames are retransmitted to ports that are configured on different vlan.
第9题：
Which three are valid methods to monitor and trend SAN port channels with DCNM？（）
第10题：
Each port that is configured to use LACP has an LACP port priority. Which statements are true about LACP port priority？ （）