An administrator just installed a new RAID controller card i

第1题：

Which of the following devices would be installed if an administrator wants to control a group of servers from a remote location？（）

• A、 VLAN
• B、 KVM
• C、 IP KVM
• D、 RAID

第2题：

Which three should be documented after upgrading a SCSI RAID controller？（）

• A、 disk utilization
• B、 installation date
• C、 adapter baselines
• D、 location slot of the RAID controller
• E、 status of the adapter card installation
• F、 RAID controller information （warranty， specifications etc.）

第3题：

第4题：

An administrator recently installed a new array controller into a server. When the server is running POST the controller does not appear as present. Which of the following could be the reason for this?（）

• A、The server BIOS firmware is out-of-date.
• B、The server does not have the correct drivers.
• C、The server hard drives have not begun to spin.
• D、The server has too little memory installed.

第5题：

The administrator has just installed a new memory module into the server. Now， the server is not showing the new memory. Which of the following should the administrator perform FIRST？（）

• A、System reboot
• B、Reseat the memory
• C、Install the latest firmware
• D、Install the latest driver

第6题：

An administrator just installed a new RAID controller card into a server. The firmware is current for the controller card. When the server is powered up the administrator notices that the RAID controller card is not recognized during POST. Which of the following is the cause of the problem？（）

• A、The hard drives were not plugged into the server correctly.
• B、The controller driver is outdated and needs to be updated from the OEMs website.
• C、The firmware for the server is too old and does not support the new RAID controller card.
• D、The cable from the controller to the hard drive backplane is not connected.

第7题：

An administrator has just finished physically replacing the system board in a Windows domain controller. Which of the following must be done before booting the server back into Windows?（）

• A、Update the time and date in the BIOS.
• B、Update the firmware on the SCSI controller.
• C、Update the firmware to the latest version.
• D、Configure IPMI on the new board.

第8题：

An administrator has just upgraded a server from non-hot plug storage to all hot plug storage. Theadministrator powers up the server， during POST the RAID controller is recognized but none of the drivelights flash.  Which of the following should the administrator do FIRST to trouble shoot the problem？（）

• A、 Check the backplane cabling.
• B、 Check the server BIOS.
• C、 Update the RAID controller firmware.
• D、 Install the latest hard drive firmware.

第9题：

A technician installed a new video card on a motherboard which has onboard video. When the monitor was plugged into the new card and the power was turned on, a no signal message appeared on the monitor. Which of the following is MOST likely the issue?（）

• A、In the BIOS, the onboard video adapter must be disabled.
• B、The video resolution is set too high.
• C、The LCD panel is defective.
• D、The drivers for the new video card must be installed before installing the card.

第10题：

A technician has just installed an upgraded graphics card. The computers power turns off before itfinishes booting. Which of the following is the cause of the problem? （）

• A、The monitor cannot display the increased resolution that is a feature of the new graphics card.
• B、The power supply does not provide enough wattage to power the new graphics card.
• C、The new graphics card is incompatible with the existing processor.
• D、The computer does not have enough RAM to support the new graphics card.