Move the RAID adapter to another slot.
Perform a baseline of the system.
Contact the reseller of the adapter for a replacement card.
Check the RAID adapter’s manufacturer for the latest drivers.
第1题：
An administrator recently installed a known good RAID adapter. During boot up， the administrator is able to access the RAID configuration utility； however， when the administrator checks for the card in the operating system， it does not show up. Which of the following should the administrator do FIRST？（）
第2题：
An administrator has just upgraded a server from non-hot plug storage to all hot plug storage. The administrator powers up the server, during POST the RAID controller is recognized but none of the drive lights flash. Which of the following should the administrator do FIRST to troubleshoot the problem?（）
第3题：
An administrator has just upgraded a server from non-hot plug storage to all hot plug storage. The administrator powers up the server, during POST the RAID controller is recognized but none of the drive lights flash.Which of the following should the administrator do FIRST to troubleshoot the problem?（）
A. Check the backplane cabling.
B. Check the server BIOS.
C. Update the RAID controller firmware.
D. Install the latest hard drive firmware
第4题：
An administrator installs a new network card in a properly functioning DC. During the Windows bootup process the DC bluescreens. Which of the following is the NEXT step？（）
第5题：
A Windows 2003 server has the operating system installed on a software RAID mirror. After a failure of one disk in the array the server will no longer boot up. The other drive is still functioning. Which of the following should be done to correct the issue？ （）
第6题：
An administrator installs a driver,reboots the DC, and logs in to configure the NIC. Once the administrator opens the NIC properties, the server bluescreens and now will no longer boot into Windows. Which of the following is the FIRST thing the administrator should do?（）
第7题：
An administrator just installed a new RAID controller card into a server. The firmware is current for the controller card. When the server is powered up the administrator notices that the RAID controller card is not recognized during POST. Which of the following is the cause of the problem？（）
第8题：
A server consists of two 72GB SCSI drives and four 146GB SCSI drives. All drives are attached to a RAID controller. The system’s administrator has decided to mirror two drives for the operating system. Which of the following is the maximum space the administrator will have remaining to use for data when using RAID 0？（）
第9题：
A user reports they cannot access the network share folder， the users workstation is configured to use automatic IP. When the administrator checks the IP address the response returns as 169.254.0.5. Which of the following should the administrator verify？（）
第10题：
An administrator installs a new network card in a properly functioning DC. During the Windows boot up process the DC bluescreens. Which of the following is the NEXT step?（）