An administrator adds a new SATA hard drive into a functiona

第1题：

A technician has lost a necessary jumper for a new hard drive that must be installed immediately.Which of the following is the BEST solution?（）

• A、Use a jumper from the motherboard where the new drive is going to be installed.
• B、Use a jumper from a hard drive that is no longer functioning.
• C、Contact the manufacturer of the new hard drive and have a replacement jumper shipped immediately.
• D、The new hard drive must be replaced

第2题：

Which of the following steps would be performed FIRST to install a fresh copy of Windows 7Professional on a new hard drive?（）

• A、Format the partition
• B、Load any RAID or SATA drivers needed
• C、Partition the drive
• D、Configure Windows settings

第3题：

第4题：

A technician is working on a new computer running Windows XP and the hard drive is formatted at 20GB but is an 80GB hard drive. There is not another partition and no extra space can be foundunder Windows explorer.  Which of the following would be the BEST way to partition the remainder of the hard drive without data loss？ （）

• A、Add another hard drive and use that available space.
• B、Run FDISK.
• C、Use the Disk Management tool.
• D、Back up all important data to an external drive then reformat the hard drive.

第5题：

After installing a new SATA hard drive the technician notices the drive is hot to the touch and is giving off a slight odor. Which of the following should the technician do? （）

• A、Install a larger fan near the hard drive to cool the system.
• B、Clean the drive with compressed air and continue to use it.
• C、Remove and replace the drive.
• D、Apply more thermal compound and reseat the drive.

第6题：

An administrator just installed a new RAID controller card into a server. The firmware is current for the controller card. When the server is powered up the administrator notices that the RAID controller card is not recognized during POST. Which of the following is the cause of the problem？（）

• A、The hard drives were not plugged into the server correctly.
• B、The controller driver is outdated and needs to be updated from the OEMs website.
• C、The firmware for the server is too old and does not support the new RAID controller card.
• D、The cable from the controller to the hard drive backplane is not connected.

第7题：

An administrator has removed a SATA hard drive from a failed server. Which of the following adapters would MOST likely be used by the administrator to transfer files from the drive to a laptop？（）

• A、SATA to SCSI
• B、SATA to HBA
• C、SATA to USB
• D、SATA to SAS

第8题：

第9题：

Which of the following will occur if a laptop SATA 1 drive is installed on a SATA 2 controller?（）

• A、The drive will run at the lower SATA 1 speed.
• B、The drive will not work due to incompatibility.
• C、The drive will run at the higher SATA 2 speed.
• D、The drive will have intermittent POST errors.

第10题：

Which of the following is eliminated when using SATA instead of PATA technology？（）

• A、Jumper selection
• B、Power connector
• C、Data port connector
• D、Hard drive LEDs